Filter
Top Products
864 ST Fireback Installation
SKU # 96100184 – 96100186 – 96100189 - 96100190
Page 2 of 2 9/15/08 Travis Industries, Inc.
4 Carefully place the floor
firebacks into position.
You must tip them under
and around the corners of
the burner.
5 Carefully replace the front
and rear grates (they rest
on top of the floor
firebacks).
WARNING:
When replacing the grate
do not drag the grate
across the firebacks (they
damage easily). You may
need to lift the burner
slightly while installing the
grate.
NOTE: These tabs are bent out when using the accent light. Make sure
to carefully bend them flush if the accent light was previously installed
(then reposition them after firebacks are installed).
6 Install the side firebacks
following the directions
below.
7 Restore the fireplace to
the correct configuration.
Place the side firebacks into position.
Remove the clips on both sides (loosen the screws
a couple turns and slide clips up and out).
b
Secure the clips to anchor
the side firebacks.
c
5/16" Nutdriver
a
The ceramic firebacks are fragile. Ensure proper alignment of individual pieces in each
step. To achieve the ideal appearance, you may need to make slight adjustments.