Filter
Top Products
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you arm or
disarm the system simply by holding the ARM / DISARM button for two seconds. If you find the
normal arming and disarming chirps annoying, they can be turned off permanently, eliminating
the need to hold the ARM / DISARM button for two seconds. To do this,
1. With the valet switch in the off position, turn the ignition key on then off.
2. Within 10 seconds, press and release the valet pushbutton switch three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating they have been
turned off.
If the chirps were off before you started, then you will hear one chirp indicating they have been
turned on.
NOTE: If the siren/horn chirps two times, regardless of the valet switch operation as described
above, then the horn and siren chirps have been turned off via programming features 7
and 8. Contact your installation center or Audiovox technical department for information
on how to reinstate the chirp feature through programming.
NOTE: Whenever the chirps are by-passed, the 4 chirp intrusion indicator and 3 chirp defective
zone indicator will always operate. Since these are important warnings to you that
something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The Lock or Unlock button on your keychain transmitter also functions as a panic switch for use
in emergency situations. To use remote panic,
1. Press and hold the Lock or Unlock button on the keychain transmitter for 3 or more seconds.
The alarm will immediately sound.
2. To stop the alarm, press and hold the Lock or Unlock button on the transmitter again for
3 seconds. If the button is not pressed, the alarm will automatically stop after 30 seconds.
Also if any transmitter button other than the Lock or Unlock button is pressed and released,
the Panic mode will be turned off immediately. The normal function of this transmitter button
will be suspended during the Panic sounding period.
NOTE: While in the Panic mode, pressing and releasing the Lock or the Unlock buttons will, if
the option is installed, lock and unlock the doors respectively. While in the panic mode,
anytime the unlock button is pressed, the panic feature will continue for the allotted 30
seconds, however, the security system will be disarmed allowing the vehicle to start.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )
This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are:
o Remote Trunk Release
o Remote Car Starter
o Remote Window Closure
o Remote Garage Door Interface
To activate the optional accessory, press and hold the option button 2 on the keychain
transmitter for 3 seconds.
Page 7