Filter
Top Products
Where to Use: Use in the room where the AUDIO/VIDEO
equipment’s infrared sensor is located.
How to Install:
1. Plug the Base Unit power cord into a standard
electrical outlet.
2. Point the Leapfrog logo on the Base Unit toward
the AUDIO/VIDEO infrared remote sensor on the
audio/video component.
3. Check to ensure that the Base Unit is located within
20 feet of the AUDIO/VIDEO equipment.
After setting up your Extension and Base Units, operate
the Signal Sender by aiming your remote at the Leapfrog
logo on the front of the Extension Unit.
Where to Use: Set up the Extension Unit in the room where
you wish to use your remote control (example: use in the
additional room wired to receive a satellite signal from your
primary receiver).
How to Install:
1. Plug the Extension Unit into a standard electrical outlet.
2. Place the Extension Unit on a level, stable surface, with
the Leapfrog logo facing you. In most cases, the unit can
be placed up to 18 feet from where you will be using
the remote control.
3. Place the Extension Unit away from the AUDIO/VIDEO
equipment and the Base Unit (in another room,
for example).
Your TERK LF-IRX Remote Control Extender consists of two units (Extension
Unit and Base Unit), an infrared extension, and two AC adapters.
Extension Unit: The Extension Unit converts
the infrared signals from your remote control into
long-range RF signals that are sent to the base unit.
The LED lamp indicates that incoming signals are
being detected.
Base Unit: The Base Unit converts the RF sig-
nals from the extension unit back to the infrared sig-
nals used to control your components. The unit con-
tains an antenna, power cord, and a jack for the
Infrared Extension. The LED light indicates that a sig-
nal is being received. The Base Unit can be placed
up to 100 feet away from the Extension Unit.
Infrared Extension: The Infrared Extension
can
be used in situations where the Base Unit can
not be placed in front of the component(s)
it is controlling. This device consists of an Infrared
diode connected to a 4 ft. extension
wire and plug.
Compatible Components:
The LF-IRX can control virtually any household device
that is operated via infrared remote control, including
the following:
• Satellite Receivers
• Digital Video Recorders (TiVo, ReplayTV)
• Cable Converter Boxes
• VCRs
• CD Players
• Stereo Receivers
• Tape Decks
Base Unit
Maximum 18'
Maximum 20'
M
a
x
i
m
u
m
1
0
0
'
Extension Unit
Base
Unit (1)
Infrared Extension (1)
Extension
Unit (1)
AC Adapter
(2)
Precautions: To ensure safe and effective operation, please be sure to read and under-
stand the following precautions before operating your TERK Remote Control Extender.
The following basic safety precautions should always be followed to reduce the risk of fire,
electric shock and personal injury:
1. Read and understand all of the instructions in this manual.
2. Follow all warnings and instructions indicated in the manual and on the product itself.
3. Do not use your LF-IRX in or near any body of water, such as a bath tub, washbowl,
kitchen sink, or laundry tub, in a wet basement, or in or near a swimming pool.
4. Be sure to place your LF-IRX on a stable, level surface. Placing the product on any
unstable surface may cause the product to fall.
5. Do not attempt to clean your LF-IRX while it is plugged in. Unplug the product from
the wall outlet before cleaning.
6. Do not use liquid cleaners or aerosol cleaners to clean your LF-IRX. Clean only with
a damp cloth.
7. This product should be operated only from the type of power source indicated on the
marking label.
8. To reduce the risk of electric shock, do not disassemble this product, but take it to a
qualified serviceperson if service or repair work is required. Opening or removing covers
may expose you to dangerous voltages or other risks and will void the warranty.
Incorrect reassembly can cause electric shock when the product is subsequently used.
9. Unplug your LF-IRX from the wall outlet and contact a qualified electronic service technician
if any of the following should occur:
A. The plug is damaged or the cord has been broken or frayed.
B. Liquid has been spilled into the product.
C. The product has been exposed to rain or water.
D. The product does not operate normally by following the operating instructions.
E. The product has been dropped or otherwise damaged and will not work.
F. The product exhibits a distinct change in performance.
• No repairs to the unit(s) should be attempted by the customer.
• NOTE: This equipment has been tested and found to comply with the limits for remote
control security devices in accordance with the specifications in sub parts C and E of part
15 of FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that Radio Frequency Energy does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on.
STEP 2: Setting Up the Base Unit
STEP 1: Setting Up the Extension UnitSystem Contents0perating Precautions