Filter
Top Products
Installation rapide
Retirez les trois piles AA ci-jointes et installez-les dans le récipient à piles.
Placez soigneusement les drapeaux rouges d’avertissement de piles dans
le récipient à piles. Respectez les indications des polarités de pile inscrites
dans le fond du récipient à piles. L’affichage devrait indiquer 888
(figure 1).
Après environ 30 secondes, l’affichage 888 disparaîtra et un point noir en
bas à droite clignotera toutes les 5 secondes (figure 2).
Votre alarme de monoxyde de carbone Atwood est maintenant opéra-
tionnelle.
Quick Set Up
Remove the three enclosed AA batteries and install them into
the battery well. Carefully place the red battery warning flags into
the battery well. Observe the battery polarity markings at the
bottom of the battery well. After approximately 30 seconds, your
CO alram will begin monitoring for CO.
Your Atwood CO Alarm is now operational.
Seven (7) years after initial power up, this unit will “chirp” every
30 seconds to indicate that it is time to replace the alarm. After
seven years the device may no longer detect carbon monoxide
accurately and should be replaced immediately. To help identify
the date to replace the unit, a label has been affixed to the side
of the alarm. Write the “Replace by” date (7 years from power
up) in permanent marker on the label.
6
6