Filter
Top Products
Rev. A.3, 5/00 Page- 11
A back plate or Securitron's Z bracket must also typically be provided for the strike plate. The
strike plate cannot be directly welded to the gate as it will not be able to flex and self
align. It must be screwed onto a surface with the washer stack used to provide
flexibility. Note that if Securitron's Z bracket is used, it typically bolts to the gate rather than is
welded as it is aluminum. Read sections 2.3, 2.3.1, and 2.3.2 for additional general information
on mounting.
FIG. 11: MOUNTING TECHNIQUES FOR GATES
Z BRACKET BOLTED TO SWING ARM
STRIKE
GF MAGNET
CONDUIT FITTING MAY EXIT TOP OR BOTTOM
Z BRACKET BOLTED TO SWING ARM
INTERFERENCE PIECE MUST
BE ADDED TO Z BRACKET
DIRECTION OF OPENING
GF MAGNET
CONDUIT FITTING
LOCK NUTS
EXTENDED ROLL PIN
SPRING
ANGLE BRACKET
STRIKE
ANGLE BRACKET
EXTENDED ROLL PIN
SINGLE SWING GATE
DOUBLE SWING GATE
SLIDING GATE
GATE
EDGES
MOTORIZED OPENING MUST BE
COORDINATED