Filter
Top Products
11 - 44
Diode check out: Diodes are checked with an ohm
meter set on the diode check, and should only pass
voltage in one direction. If it passes voltage in both
directions or not at all the diode is bad and needs to be
replaced.
.
Contact resistance is 0.1-0.3 ohms when correct.
Normally open contacts manually activated. contact resistance is 0.1-0.3 ohms when correct.
2 sets of contacts, one normally open, one normally closed. Contact resistance is 0.1-0.3 ohms when correct.
Normally open contacts manually activated. Contact Resistance is 0.1-0.3 ohms when correct.
(A) Measure with steering arms in neutral.
Normally open contacts manually activated. Contact Resistance is 0.1-0.3 ohms when correct.
(A) Measure with steering arms in neutral.
Key Switch Off Run Start
B 11.50-13.00 Volts 11.50-13.00 Volts 11.50-13.00 Volts
A 11.50-13.00 Volts 11.50-13.00 Volts
S 11.50-13.00 Volts
L 11.50-13.00 Volts 11.50-13.00 Volts
Seat Switch Off Run Start
Red/Yellow 11.50-13.00 Volts 11.50-13.00 Volts
Purple 11.50-13.00 Volts 11.50-13.00 Volts
PTO Switch Off Run Start
Brown 11.50-13.00 Volts
Purple/White Connected to PTO Clutch
Purple 11.50-13.00 Volts 11.50-13.00 Volts
Red/Green 11.50-13.00 Volts 11.50-13.00 Volts
Brown/Yellow 11.50-13.00 Volts
Left Hand Neutral Switch (A) Off Run Start
Brown/Yellow 11.50-13.00 Volts
White 11.50-13.00 Volts 11.50-13.00 Volts
Right Hand Neutral Switch (A) Off Run Start
Red/Green 11.50-13.00 Volts 11.50-13.00 Volts
White 11.50-13.00 Volts 11.50-13.00 Volts
Yellow/Red 11.50-13.00 Volts 11.50-13.00 Volts