Aquacal T115 Heat Pump User Manual


 
30
START
Is the thermostat turned UP,
and the toggle or rocker switch
selecting either the
SPA or POOL
thermostat ?
START
Is the thermostat turned UP,
and the toggle or rocker switch
selecting either the
SPA or POOL
thermostat ?
Check to be sure the
power light is on. If the
power light is off, check
for a tripped circuit
breaker. Reset the
circuit breaker if
necessary.
Check to be sure the
power light is on. If the
power light is off, check
for a tripped circuit
breaker. Reset the
circuit breaker if
necessary.
Position controls to
select POOL or SPA;
rotate selected
thermostat to the
maximum setting.
Position controls to
select POOL or SPA;
rotate selected
thermostat to the
maximum setting.
Is the heater
operating correctly?
Is the heater
operating correctly?
Is the heater
operating correctly?
Is the heater
operating correctly?
Check to see that the
pool pump is operating
and the flow light is on.
Make sure all water
valves are in the correct
position and the filter
and pump basket are
clean.
Check to see that the
pool pump is operating
and the flow light is on.
Make sure all water
valves are in the correct
position and the filter
and pump basket are
clean.
The heater is equipped
with a five minute delay.
Wait at least five
minutes to allow the
timer to reset.
The heater is equipped
with a five minute delay.
Wait at least five
minutes to allow the
timer to reset.
Contact
AquaCal for
Assistance at:
800-786-7751
Contact
AquaCal for
Assistance at:
800-786-7751
Problem
Solved.
(Re-set thermastats
to desired
temperature)
Problem
Solved.
(Re-set thermastats
to desired
temperature)
Yes No
No
NoYes
Yes
Is the unit operating
correctly?
Is the unit operating
correctly?
Yes
No
Troubleshooting Flow Charts
Heater Fails to Operate
Analog Controls - 12/22/03