Filter
Top Products
10
GETTING YOUR HEAT PUMP STARTED & STOPPED
ATTENTION
:
THIS IS A QUICK-START GUIDE…For more complete information
concerning the digital controller features and programming, see: Owner’s
Instructions for HP7 Digital Heat Pump Controller, located in the appendix of this
manual.
INITIAL START UP
1. Start the water circulator pump.
NOTE: T
HE
P
OOL
F
ILTER
P
UMP MUST BE OPERATING FOR THE HEAT PUMP TO BEGIN
HEATING
. A
NYTIME THE
P
OOL
F
ILTER
P
UMP IS TURNED OFF
,
THE HEAT PUMP WILL ALSO BE
OFF
.
2. Ensure that the unit has power connected; display should be illuminated.
3. If the display is blank, be certain the breaker and heater disconnect are switched
to “ON”.
HOW TO OPERATE THE CONTROLS
1. Once the unit has power connected, the display should read either “OFF” or
the actual pool or spa water temperature. If other than “OFF” or the actual
water temperature are displayed, see the “Trouble Shooting” section.
2. If the display reads “OFF”, press the up arrow key until the display reads
60°F or higher.
NOTE: T
HE DISPLAY READS CURRENT POOL
/
SPA WATER TEMPERATURE WHEN THE
DESIRED TEMPERATURE IS SET TO
60°F
OR ABOVE
. W
HEN THE DESIRED WATER
TEMPERATURE IS SET BELOW
60°F
THE DISPLAY READS
“OFF”.
3. Once the unit is displaying the current water temperature, the system is
ready to operate. Locate the POOL / SPA selector key on the control panel;
by pressing this key, you can select between the pool and spa mode.
4. Using the POOL / SPA selector key, select the pool mode. When the pool
mode has been selected, the pool indicator light, located on the left side of
the display, will be illuminated.
5. With the control in the pool mode, use the UP / DOWN arrow keys to set the
desired pool water temperature.
6. If heater is also being used to heat a spa, repeat the previous two steps to
program the desired spa water temperature.
7. The heat pump will now maintain the desired water temperature for the
mode selected: POOL, or SPA.
Page 4 of 5
Not