Aprilaire 4200 Air Cleaner User Manual


 
ACTIVE CLEANING OPTIONS
OPERATION
The exclusive Aprilaire Air Cleaner Control (see Figure 3) is installed by your contractor at a location that is convenient for you.
It may be located next to your thermostat, on the air cleaner or near your heating and cooling equipment.
1
Filtering
When the air cleaner is cleaning the air, either at your
command or when the heating and cooling system is operating,
bars on the display will sequence on and off to let you know
that it is working
2
Filter Life Indicator
This area of the display indicates filter usage. Bars will build
indicating usage increments of 20%, based on how the Air
Cleaner Control was set up. When all bars are filled and begin
to flash, it is time to change the filter. See the Maintenance
section on page 5 for more details.
3
Active Cleaning
Four selections are available to choose the Air Cleaner Control
option that is best for you, beyond the cleaning that occurs
whenever your equipment is heating or cooling.
2
1
3
2
FIGURE 3
90-1339
Constant Cleaning:
This option will provide the maximum amount of air cleaning
available. The air cleaner will be active for 24 hours a day,
seven days a week.
Automatic (30 min./hr):
The air cleaner will run a minimum of 30 minutes every hour.
The Air Cleaner Conrol will monitor the amount of time your
heating and cooling system runs; if 30 minutes is not reached
the Air Cleaner Control will automatically turn on the air cleaner.
This will maximize the amount of air cleaning while minimizing
energy consumption.
Event Clean (3 hour cycle):
When selected, the air cleaner will run for 3 hours
continuously and then turn off. This option only cleans the air
when needed; an example would be after vacuuming.
Allergies (24 hour cycle):
When seasonal allergies spike and outside air quality is at its
worst, choose this option to run your air cleaner continuously
for 24 hours then turn off.
To select any of the options below, simply press the corresponding button, and an arrow will appear next to the button indicating
which option has been selected. To cancel a selection, simply press the button again.
4