Filter
Top Products
4
TESTING
Turn the HOT HANDLE (1) clockwise and the
COLD HANDLE (2) counterclockwise to the
off position.
Unscrew and remove the SPOUT STREAM
STRAIGHTENER (3).
Slowly turn on the water supplies.
Operate the HANDLES (1, 2) to flush water
lines thoroughly. Check SPOUT (4) connection
for leakage.
Turn the Handles off. Replace the SPOUT
STREAM STRAIGHTENER (3).
1
2
3
4
M968652 Rev. 1.1
2
VALVE TRIM
6
5
SERVICE
Place the ESCUTCHEON SEALS (1) over the VALVE BODIES (2).
Thread the VALVE ESCUTCHEONS (3) into the VALVE BODIES (2).
Align the HANDLE STEM (4) with the SLEEVE (5) as necessary.
Thread the VALVE ESCUTCHEON (3) into the BODIES (2) until the
ESCUTCHEON (3) contacts the finished deck.
3
INSTALL HANDLES
Turn off the water supplies
Turn HANDLE (1) to the off position.
Remove the INDEX CAP (2) and the HANDLE
SCREW (3). Pull the HANDLE BASE (4) off and
remove ADAPTER (5).
Unscrew the VALVE ESCUTCHEON (6).
Unscrew the VALVE LOCK NUT (7) and
remove. A 17mm deep socket is required.
Remove the CARTRIDGE (8) by
pulling up on the SLEEVE (9).
Remove the SCREW (10)
from the CARTRIDGE (8).
Remove the SPRING CLIP (11).
Remove the STOP WASHER (12).
Turn it 90˚ and replace.
Replace the SPRING CLIP (11).
Reverse the above steps to
reassembly the components.
If the spout drips, operate the handles several
times from the off to the on position. Do not
force - the handles only turn 90˚
90$
To change the direction of handle rotation
Turn VALVE into OFF position.
Push ADAPTER (1) into HANDLE (2)
in a way that the male square on the
ADAPTER (1) fits in the female square
of the HANDLE (2).
Push HANDLE (2) and ADAPTER (1)
onto VALVE STEM (4).
Turn VALVE into OFF position.
Push ADAPTER (1) into
HANDLE BASE (2).
Push HANDLE BASE (2)
and ADAPTER (1) onto
VALVE STEM (3).
Push CROSS (4) onto
ADAPTER (1).
Assemble and tighten
HANDLE SCREW (5).
Push INDEX CAP (6) in
top of HANDLE (4).
Push out ADAPTER (1) carefully.
Turn ADAPTER (1) either 45˚ or 90˚
so that male square on ADAPTER (1)
catches different female square in
HANDLE BASE (2).
Assemble and tighten HANDLE
SCREW (3).
Push INDEX CAP (5) in top of HANDLE (2).
Check alignment, if not satisfactory aligned;
LEVER HANDLE
CROSS HANDLE
2
3
4
1
5
6
7
10
9
11
12
8
1
2
3
4
5
1
1
2
2
3
3
4
4
6
5
5
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean
water may also be used, if desired. No additional cleaning products are required.
EverClean™ Finish Care Instructions
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.