Filter
Top Products
M968896
1A
SPOUT INSTALLATION
2
INSTALL HANDLE ADAPTERS
Place the ESCUTCHEON SEALS (1) into groove of DECK ADAPTERS (2).
Align the HANDLE STEM (3) with the SLEEVE (4) as necessary.
Thread the HANDLE ADAPTER (5) into the VALVE BODY (6) until the
DECK ADAPTERS (2) contacts tight against the finished deck.
GROOVE
Position the RUBBER RING (14) in the groove in
the base of the ESCUTCHEON (11). Push the
SPOUT (12) with ESCUTCHEON (11) down onto
the SPOUT ADAPTER (8) and tighten the SET
SCREW (13) securely with the 5mm HEX
KEY (15) supplied.
GROOVE
Lubricate the SPOUT ADAPTER O-RING (6) and
SPOUT O-RING (7).
Push SPOUT ADAPTER (8) on SPOUT SHANK (5)
and align slot in SPOUT ADAPTER (8) with 3/16"
drilled hole.
Tighten SPOUT ADAPTER SET SCREW (9) securely
with 4mm HEX KEY (10) supplied.
FINISHED
DECK
SLOT
3/16" DRILLED
HOLE
1
1
6
5
4
2
6
10
8
8
7
7
5
11
13
12
15
9
11
3
3
INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A". Tighten
STEM SCREW (3) to secure ADAPTER (1).
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting
male teeth on ADAPTER (1) to female teeth in HANDLE (4).
Thread LEVER HANDLE ASSEMBLY (4) onto DECK
ADAPTER (5) until snug against mounting surface.
Repeat steps for opposite handle.
4
2
5
3
TOP
Figure "A"
SPLINE END DOWN
THREAD ON
TO DECK
ADAPTER
14