American Standard 2903.018W Indoor Furnishings User Manual


  Open as PDF
of 2
 
SAVONA OVAL™ WHIRLPOOL
HIGH GLOSS ACRYLIC
© 2005 American Standard Inc.
1524mm
(60)
ROUGH
FLOOR
1-1/2 O.D.
TAILPIECE
▲OUTLINE OF
CUTOUT - USE
TEMPLATE
241 mm
(9-1/2)
1073mm
(42-1/4)
489mm
(19-1/4)
INTEGRAL
FEET
SUPPORT
95mm
(3-3/4)
51mm
(2)
537mm
(21-1/8)
76mm
(3)
C
L
OF DRAIN
OUTLET
540mm
(21-1/4 )
1-1/2 N.P.T.M.
THREADS
35mm
(1-3/8)
305mm(12) X 229?mm(9)
CUTOUT IN FLOOR FOR DRAIN
98mm
(3-7/8)
PROVIDE ACCESS
TO PUMP FOR
SERVICING ON ALL
INSTALLATIONS
ON/OFF
SWITCH
PUMP
(MAY
EXTEND
BEYOND
RIM BY 1-1/2")
SEE FTTG.SPECS
FOR DIMENSION
C
L
OF SUPPLIES
C/L OF
SPOUT
C/L OF
VALVES
C/L OF
SHOWER ARM
1651-1981mm
(65-78)
OPTIONAL
102mm
(4)
305mm
(12)
SAFE-T-HEATER
REMOVABLE
BLANK
1524mm
(60)
ROUGH
FLOOR
1-1/2 O.D.
TAILPIECE
▲OUTLINE OF
CUTOUT - USE
TEMPLATE
241 mm
(9-1/2)
1073mm
(42-1/4)
489mm
(19-1/4)
INTEGRAL
FEET
SUPPORT
95mm
(3-3/4)
51mm
(2)
537mm
(21-1/8)
76mm
(3)
C
L
OF DRAIN
OUTLET
540mm
(21-1/4 )
1-1/2 N.P.T.M.
THREADS
35mm
(1-3/8)
305mm(12) X 229?mm(9)
CUTOUT IN FLOOR FOR DRAIN
98mm
(3-7/8)
SEE FTTG.SPECS
FOR DIMENSION
C
L
OF SUPPLIES
C/L OF
SPOUT
C/L OF
VALVES
C/L OF
SHOWER ARM
1651-1981mm
(65-78)
OPTIONAL
102mm
(4)
305mm
(12)
GENERAL SPECIFICATIONS FOR 2903 WHIRLPOOL
60 x 42-1/4 x 21-1/4 In.(1524 x 1073 x 540mm)
107 Lbs. (49 Kg.)
640 Lbs. (291 Kg.)
64 Gal. (243 L)
53 Gal. (201 L)
45 x 23 In. (1143 x 584mm)
53 x 32 In. (1346 x 813mm)
15 In. (381mm)
35 Lbs./Sq.Ft. (166 Kgs./Sq.m)
27.8
45.4
WHIRLPOOL ELECTRICAL SPECIFICATIONS
1.6 HP, 9.7 AMPS, 120V.SYSTEM I PUMP
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
GENERAL SPECIFICATIONS FOR 2903 BATHING POOL
60 x 42-1/4 x 21-1/4 In.
(1524 x 1073 x 540mm)
107 Lbs. (49 Kg.)
640 Lbs. (291 Kg.)
45 x 23 In. (1143 x 584mm)
53 x 32 In. (1346 x 813mm)
15 In. (381mm)
35 Lbs./Sq.Ft. (166 Kgs./Sq.m)
27.8
45.4
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND OR PENINSULA TYPE INSTALLATION. SUMP OF BATH IS
SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIALS BY OTHERS.
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING SYSTEM PIPING
AND DRAIN OVERFLOW. MOUNTING HOLES DRILLED BY INSTALLER.
OPTIONAL TILING BEAD KIT AVAILABLE.
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
ON SYSTEM II: CONTROL MODULE TO BE MOUNTED BEHIND ACCESS PANEL, A MINIMUM OF (152mm) 6 ABOVE ROUGH FLOOR.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1 / CSA Certified.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided leaflet.
■
●
 previous