American Standard 1660.14 Plumbing Product User Manual


  Open as PDF
of 3
 
M968617 Rev.1.2
4
INSTALL ESCUTCHEON
Align ribs on back of ESCUTCHEON (1, 2), with slots in BODY SPRAY (3). Push ESCUTCHEON (1, 2) against BODY
SPRAY (3) until ESCUTCHEON (1, 2) snaps into place.
Turn on water supply and test installed BODY SPRAY (3) for leaks and proper operation.
FINISHED WALL
6
4
1
3
INSTALL BODY SPRAY
Remove the PLASTER GUARD (1) if not already removed.
Make sure the O-RING (2) and FLANGE GASKET (6) are installed on the BODY SPRAY (3). Thread BODY SPRAY (3)
into the ELBOW (4).
Tighten BODY SPRAY (3) using WRENCH (5) supplied until flush against finished wall and FLANGE GASKET (6) is
compressed. Turn on water supply and test installed BODY SPRAY (3) for leaks and proper operation.
2
2
6
3
FINISHED WALL
5
5
1
1 2
2
4
3
5
CARE:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
3
ALIGNMENT RIBS ON
BACK OF ESCUTCHEON
ALIGNMENT RIBS ON
BACK OF ESCUTCHEON
SLOTS
 previous