Filter
Top Products
3
Drill a clearance hole
inside the perimeter
line of the template.
2
Mount the faucet and drain
assembly (not included) on
the lavatory following faucet
manufacturer's instructions.
Be certain to apply a bead of
sealing putty on the underside
of the drain (Part "A") in order
to ensure a watertight seal
between the lavatory and
drain. Remove excess putty
after installing drain on
lavatory.
4
Before applying the sealant,
place the lavatory temporar-
ily into the cut-out. Check
for alignment and clearance.
Then mark the lavatory
countertop in several places
as a guide for the installa-
tion location.
and
After checking fit and
alignment, turn lavatory
upside down and apply
a generous portion of
sealant around the
underside of the rim
near the edge. Carefully
lower lavatory in place,
align with marks made
earlier, and press down
firmly. Allow sealant to
set before connecting
supplies and drain.
6
Connect supply line to
faucet (finger tight) and
carefully bend tubes to
engage with the supply
shut-off valves. Tighten
connections at faucet
and shut-off valves for
secure seal.
7
Connect trap to drain
assembly hand tight to
check alignment. It may
be necessary to cut off
part of the tailpiece
(area "B") or part of
the horizontal leg of the
trap (area "C"). Secure
joints for watertight
assembly.
B
C
Shut-Off
Valves
730524-100
Cut opening around
the perimeter of the
template.
Perimeter
of template
Perimeter
of template
5
A