Filter
Top Products
3
Before Use
10
Important!
• Leave the unit in an upright position for at least 2 hours before use.
• Always place the unit on an even surface.
• The power cord has a built-in A.F.C.I. (Arc Fault Circuit Interrupter) circuit breaker
for added safety. If the power supply is interrupted, please press the reset
button to reconnect the unit to the power source. The green light should be on.
• Make sure the unit is connected to a correctly grounded power supply.
• For proper operation, the unit must be vented to the outside.
• Do not cover or obstruct the appliance inlet or outlet grilles.
• To avoid the risk of shock, the product should never be used in bathrooms, shower rooms
or in any other steamy or wet areas.
• Always transport the unit in an upright position.
• Do not sit or stand on the unit.
• Do not place objects on the unit.
• Do not touch the unit with wet/damp hands or when standing barefoot.
• Drainage of the water container is required before moving the unit or
putting it into storage.
• If the electric socket is different from the plug provided, have a professionally qualified
electrician replace the outlet with a suitable one. Avoid the use of adaptor plugs, multiple
sockets and/or extension cords; if their use is necessary, ensure that they conform to the
current safety regulations.
• Do not pull the power cord or place it near a source of heat; always unroll it completely
to avoid the possibility of dangerous overheating.
• If the power cord is damaged, it must be replaced by a qualified person.
THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY IF THE ABOVE
INSTRUCTIONS ARE NOT FOLLOWED.
Remote Control
To Operate the Remote Control:
Insert batteries by pulling down on front cover (See fi g. 1).
Be sure the remote is pointed at the unit at all times.
1. To Set the Clock:
• Press the TIME button for 3 seconds.
• The hour digits will fl ash. Press UP or DOWN to adjust the hour.
• Press the TIME button. The minute digits will flash.
Press UP or DOWN to adjust the minutes.
• Press the TIME button when fi nished.
2. To Turn Unit ON:
• Press the ON / OFF button
3. To Adjust TEMPERATURE:
• Adjust temperature using the UP / DOWN buttons
4. To Adjust FAN SPEED:
• Press FAN button to select speed.
5. To Set the TIMER:
A. SET START TIME
• Press timer ON button and set the On hour using
the UP and DOWN buttons.
• Press timer ON button and set the minutes using
the UP and DOWN buttons.
• Press timer ON to finish.
B. SET OFF TIME
• Press the timer OFF button and set the Off hour using
the UP and DOWN button.
• Press the timer OFF button and set the minutes using
the UP and DOWN buttons.
• Press timer OFF to finish.
6. To Set SLEEP MODE:
• Make certain unit is operating in Cool Mode.
• Set the desired starting temperature.
• Press SLEEP MODE button.
7. To set Auto Grill Mode:
• Press the SWING button for moving louvers
• Press the SWING button again to stop louvers from moving
10:09
72
F°
ON/OFF UP
FAN DOWN
TIME
SLEEP
SWING
MODE
fig.1
Slide
Cover
Down