Filter
Top Products
When the water tank is full, the unit will switch off automatically and beep
15 times, the TANK FULL LED on the control panel will light up. The tank needs
to be emptied:
• Remove the water tank by pulling the clasp under the bottom.
• Empty the water tank.
• Push the water tank gently back in place, when done properly the
WATER FULL LED will turn off.
1. Do NOT take away the fl oat from the water tank. The water full sensor will
no longer be able to detect the water level correctly without the fl oat and
water may leak from the water tank.
2. If the water tank is dirty, wash it with cold or lukewarm water. Do not use
detergent, scouring pads, chemically treated dust cloths, as these can scratch
and damage the tank and cause water leakage.
3. When replacing the drainage tank, press the tank fi rmly into place with both
hands. If the tank is not positioned properly, the sensor will still be activate,
and dehumidifi cation can not operate.
Pull
Emptying The Water Tank
8