Filter
Top Products
7
GB
When the water container is full, the compressor and
the ventilator stop functioning, LED [4] will lit.
Switch off the unit and remove the plug from the
mains.
• Place the water tray flat on the floor under the drain.
• Remove the drain knob.
• Remove the rubber plug and fill the water tray then replace the plug to stop
the water flow. Empty the tray and repeat this process until all water has been
removed.
• Replace the rubber plug and the drain knob, plug the unit in and switch on. The
LED [4] should now be out.
Rubber plug Water tray
Drain control
EMPTYING THE INTERNAL WATER CONTAINER
Switch off the unit and remove the plug from the mains.
• Remove the drain knob and the rubber plug.
• Connect the correct water tube onto the water outlet.
• Place the other end in a normal drain.
• Make sure that the tube is free from twists and bends.
The tube must incline over its entire length.
Dehumidification
If the unit will be used mainly as dehumidifier, do not connect
the exhaust hose and let the warm air return in the room.
Continuous drainage is then convenient and more efficient.
PERMANENT DRAINAGE