Filter
Top Products
4
Features and Benefits
How the Air Purifier Works
5
Control Panel and Remote Control Operation
1. Plug the unit into a 120V mains outlet and press the POWER (A)
button. The unit will start operating in the lowest speed.
The UV lamp and Ionizer will be on. Note that these are always
the initial conditions when the unit has been disconnected
from the 120V mains power. If the unit is turned on while
having remained connected to power, it will turn on with the
same UV lamp and Ionizer settings as when it was turned off.
The speed setting will also be kept, if the unit is turned on with
the TIMER (B) button or Remote Control.
2. With each press on the POWER (A) button, the unit will cycle
through the following sequence:
Speed 1 (Lowest speed), Speed 2, Speed 3, Off, Speed 1…
The selected speed will be indicated by the green light next
to the “1”, “2”, or “3” printing.
3. With each press on the IONIZER (C) button, the Ionizer will
cycle on and off. When the Ionizer is on, the green light next to
the IONIZER (C) button is lit.
4. With each press on the UV (D) button, the UV lamp will cycle on
and off. When the UV lamp is on, the green light next to the UV
(D) button is lit.
5. The Timer functions, which are controlled by the TIMER (B) button,
are as follows:
a. With each press on the TIMER (B) button, the Timer will cycle
through the following sequence:1hr, 2hrs, 4hrs, 8hrs, Timer off
(but the unit keeps operating), 1hr…The selected Timer interval
(in hours) will be indicated by the green light next to the
“1”, “2”, “4” or “8” printing.
b. The unit will operate for the selected Time interval (1 hr, 2 hrs,
4 hrs or 8 hrs) and then turn off the unit. After the appropriate
time period has passed the green light will move to the next
lower position in order to show the remaining time.
6. The Remote Control turns the unit on and off (see point 1 above).
For long operating distance the Remote Control should be pointed
at the area just below the POWER (A) button.
D: UV
C: IONIZER
B: TIMER
A: POWER
Placement of the AM-45 Air Purifier
Attention: Before deciding on a location for your AM-45 Air Purifier, carefully
read all the operating instructions as well as all the following information.
1. Do not place this unit in close proximity to electronic devices that are sensitive to electrical fields.
2. Do not place this unit on metal shelving or on any electrical device. The AM-45 Air Purifier may be
placed on the floor, nightstand, table or desk with its air outlet facing the user in order to allow proper
air flow.
3. In order to prevent dirt build-up it is recommended to keep the unit at least 1.5 ft.
(45cm) from any non-washable surface.
The principle upon which the ionizer works is Ionization. The process of ionizing accelerates the
fallout of pollutants from the air. These pollutants may adhere to surrounding surfaces, causing a
dark smudge. Therefore placement of the unit away from all non-washable surfaces is a must!
• High performance air purifier/ionizer for large areas and extended use.
• Electronic Control
• Three Speeds
• A timer that allows the user to operate the unit continuously, or at 1, 2, 4, or 8 hour increments
• Quiet Operation
• Mesh pre-filter
• Electrostatic filter captures even the smallest airborne particles
• Granulated Active Carbon Filter
• PCO (Photo Catalytic Oxidation) filter working in conjunction with a UVA lamp to kill
bacteria, viruses and reduce odors.
• Negative air ionizer