Filter
Top Products
8
Important: how to wire a 13 amp plug
The wires in the mains lead on this appliance are
coloured in accordance with the following code:
GREEN AND YELLOW – EARTH BLUE – NEUTRAL BROWN – LIVE
As the colours may not correspond with the markings
identifying the terminals in your plug proceed as
follows:
The
GREEN AND YELLOW wire must be connected to the
terminal in the plug which is marked with the letter
E or with the earth symbol
or coloured green and
yellow.
The BLUE wire must be connected to the terminal marked N or coloured black.
The BROWN wire must be connected to the terminal marked L or coloured red.
ELECTRIC CONNECTION
GREEN/YELLOW
Earth
BLUE
Neutral
BROWN
Live
FUSE
13 Amp
Cord clamp
GB
STORAGE
First of all switch off the unit and pull the plug.
Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,
detergents or other cleansing solutions.
Filter
The single layer screen filter cleans the circulated air. The filter needs to be cleaned
regularly with a vacuum cleaner to avoid blocking the air flow.
• Push the two clips on the filter housing downward and pull the filter housing
forward and out of the unit.
• Remove the rear retainer from the housing by gently prising it from the retaining
clips.
• Insert the screen filter aligning the two cut outs with the clips on the top of the
filter housing.
• Reverse the procedure to re-fit the housing in the air conditioner.
Notice! Never use the air conditioner without filter.
See the instructions "Emptying the water container" on page 7.
• Drain the condensed water completely.
• Clean (or replace) the filter.
• Put the unit on a sunny day in fan mode for a couple of
hours to ensure that the inside becomes completely dry.
• Store the power cable as shown, protect the unit against
dust and store in a dry place not accessible for children.
Cable storage
CLEANING