Filter
Top Products
Page -8- Form No. 71274A Nilfi sk ALTO Operator’s Manual - SCRUBTEC R Manual Steering
A
B
C
D
E
E, F
Machine Control Panel
On/Off Key Switch (See fi gure 1, Item D)
The key switch turns “ON” the power to the control panel. “O”
is the “OFF” and “I” is the “ON”.
Brush Up/Down Switch (See fi gure 1, Item A)
To lower brush head, push the brush switch in the down (+)
position. To lower the brush head to maximum brush pres-
sure, continue to hold the switch in the down (+) position until
the travel stops. The brush motors will start and solution will
fl ow (provided the solution is turned “ON”) when the machine
begins to traverse. To raise the brush head, push the brush
switch in the up (-) position until the brush head travel stops
or desired position is reached.
Squeegee Up/Down Switch (See fi gure 1, Item B)
The squeegee switch is used to raise and lower the squee-
gee and to turn on and off the vacuum motor. The vacuum
motor is turned on when the switch is placed in the middle
or lower position. NOTE: When the squeegee switch is
placed in the lower position, the vacuum motor will turn
on.
To raise the squeegee, place the switch in either the middle
or up position. The middle position is used for one touch con-
trol. The vacuum motor will stop, after a short delay, when
the switch is placed in the up position.
Hour Meter (See fi gure 1, Item E)
The hour meter is located on the front display. You must
toggle screens using LCD display button. The hour meter
indicates the number of hours the machine has operated. It
displays brush motor, vacuum motor, traverse motor and total
key on times.
Battery Meter (See fi gure 1, Item F)
The battery meter indicates the relative charge on the battery
pack. The battery meter is located on screen 1 on the front
display. See page 7.
Solution Flow Control (See fi gure 1, Item C)
The solution fl ow switch regulates the fl ow of chemical solu-
tion to the fl oor. To increase the fl ow, toggle (+). To decrease
the fl ow, toggle (-). To shut off the solution, toggle - until no
indicators are visible on display. NOTE: DO NOT run dry!
NOTE: No solution will fl ow when the machine does not
traverse.
Circuit Breakers
The circuit breaker reset buttons are located on the back side
of the front cover below front display. The breakers are as
follows:
Item A - Main (5 amp)
Item B - Key Switch (5 amp)
Figure 1