Filter
Top Products
OPERATIONS OF CONTROLS AND GAUGES
SCRUB BRUSHES SWITCH
The Brushes Switch (AK) is located on the console to the left of the steering wheel in the “SCRUBBING” section. This switch in the position marked
“LOWER” will lower the scrub brush deck and activate the three scrub brushes. The Brush Rotation Switch (AM) and the Brush Pressure Switch
(AJ) can not be activated unless this switch is in the “LOWER” position. This switch in the “RAISE” position will stop the brushes from rotating and
raise the scrub brush deck.
BRUSH ROTATION SWITCH
The Brush Rotation Switch (AM) is located on the console to the left of the steering wheel in the “SCRUBBING” section. This switch reverses the
rotation of the scrub brushes. This switch has two positions, “NORMAL” and “REVERSED”. This switch can not be activated unless the Scrub Brush
Lift Switch is in the “LOWER” position. The switch will light when activated.
BRUSH PRESSURE SWITCH
The Brush Pressure Switch (AJ) is located on the console to the left of the steering wheel in the “SCRUBBING” section. This switch applies additional
downward pressure to the scrub brushes. This switch has two positions, “NORMAL” and “HEAVY”. This switch can not be activated unless the Scrub
Brush Lift Switch is in the “LOWER” position. The switch will light when the switch can be activated.
SQUEEGEE BLADE SWITCH
The Squeegee Blade Switch (AL) is located on the console to the left of the steering wheel in the “SCRUBBING” section. This switch in the position
marked “LOWER” will lower the squeegee and activate the squeegee vacuum. This switch in the “RAISE” position will stop the squeegee vacuum
and raise the squeegee. A switch activated by the forward-reverse foot pedal will automatically raise the squeegee if it is in the lowered position and
the machine is in reverse.
HIGH RECOVERY WARNING LIGHT
The High Recovery Warning Light (AH) is located on the console to the left of the steering wheel beside the “SCRUBBING” section. The recovery
warning light will illuminate approximately 5 minutes before the recovery tank is full, giving ample time to complete the scrubbing cycle before the
mechanical fl oat shuts off the vacuum to the recovery tank.
LOW SOLUTION WARNING LIGHT
The Low Solution Warning Light (AG) is located on the console to the left of the steering wheel beside the “SCRUBBING” section. The Solution
Warning Light will illuminate when the solution tank is empty, marking the end of the scrubbing cycle.
AH
AG
AL
AM
AK
AJ
FIGURE 6
A-12 / ENGLISH
A-12 - FORM NO. - 56041719 - CR 1500