Filter
Top Products
ATTIX 550-01/550-11 MOBIL/550-21/590-21
ATTIX 12 GALLON / ATTIX 12 GALLON RDF
ATTIX EC 12 GALLON AS/E
16
1)
Option depending on model
Appliance socket
Use the socket on the vacuum
cleaner for the purpose defi ned
in the operating instructions
only.
Before plugging an appliance
into the appliance socket:
1. Switch off the vacuum clea-
ner
2. Switch off the appliance to
be connected.
CAUTION!
Follow the operating instruc-
tions and safety instructions for
appliances connected to the
appliance socket.
Transport
After sucking up water, do not
tilt the cleaner or transport it in
a horizontal position.
Before starting the vacuum
cleaner
Before starting the vacuum
cleaner, check that it is in
proper condition. Plugs and
couplings in power cords must
at least have splash protection.
Regularly check whether the
power cord is damaged or
shows signs of aging.
Before using the cleaner, ensu-
re that the cover and power
cord are intact. (There is risk of
electrocution if they are dama-
ged.)
Never use the vacuum cleaner
if the fi lter element is damaged.
During use
Do not damage the power cord
(e.g. by moving over it or pulling
or squeezing it).
Disconnect the power cord by
pulling the plug only (do not pull
or tug the power cord).
CAUTION!
Before sucking in liquids, remo-
ve the fi lter bag and check the
performance of the fl oater (see
section 7.2.3).
If foam appears, stop
work immediately and empty
the tank.
Maintenance and repair
CAUTION!
Always pull out the mains
plug before cleaning and ser-
vicing the vacuum clea -ner.
Only carry out maintenance
work described in the operating
instructions.
CAUTION!
Use original Alto accessories
and parts only. The use of
other parts can adversely affect
safety.
CAUTION!
Do not make technical modi-
fi cations to the vacuum cleaner.
They could endanger your
safety.
For further maintenance or re-
pair work and the replacement
of a faulty power cord please
contact the Alto service de-
partment or an authorized Alto
workshop.
Electrical connections
Check the rated voltage of the
vacuum cleaner before con-
necting it to the mains supply
system. Ensure that the voltage
shown on the rating plate cor-
responds to the voltage of the
local mains power supply.
If you are using an extension
cord, use only those specifi ed
by the manufacturer or higher
quality ones (see section 9.4
"Technical data").
It is recommended that the
vacuum cleaner is connected
via a residual current circuit
breaker. This device stops the
supply of electricity if the leaka-
ge current to earth exceeds 30
mA for 30 ms or it has an earth
tester circuit.
When using an extension cord,
check the minimum cross-sec-
tions of the cable:
Cable length Cross section
m mm
2
up to 20 1.5
20 to 50 2.5
Arrange the electrical parts
(sockets, plugs and couplings)
and lay down the extension
cord so that protection class is
maintained.
CAUTION!
Never spray water on to the
upper section of the vacuum
cleaner: danger for persons,
risk of short-circuiting.
Observe the latest edition of the
IEC regulations.