Filter
Top Products
Figure # 17
Figure #18
Figure #19
Page -22- Nilfi sk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795
HOW TO OPERATE THE MACHINE
How To Traverse Machine
NOTE: Put the machine in the slow traverse speed (see fi gure #17).
Use the machine in an area that has no furniture and objects until you
can do the following:
1. Move the machine in a straight direction, forward and backward.
2. Stop the machine safely.
3. Move the machine in a straight direction after you turn the machine.
To move the machine, follow this procedure:
1. Turn the key switch “ON” position.
2. Put the brush switch in the “UP” position.
3. Raise the squeegee.
4. To go forward, push one or both of the yellow forward switches (see
fi gure #18).
5. To stop the machine, release the yellow forward switches.
6. To go backward, push in on the white reverse button and one of the
yellow forward switches at the same time (see fi gure #19).
7. To turn the machine, push the rear of the machine to the side.
8. When you stop the machine, turn the key switch “OFF”.
How to Clean a Floor
WARNING!
Water solutions or cleaning materials used with this type of machine
can leave wet areas on the fl oor surfaces. These areas can cause
a dangerous condition for the operator or other persons. Always put
CAUTION signs near the area you are cleaning.
To clean a fl oor, follow this procedure:
1. Put the water and a cleaning chemical in the clean solution tank.
2. Turn the key switch “ON”. If one touch feature is used, press the green
button and proceed to step 6 (deluxe models only).
3. Lower the squeegee.
4. Put the brush switch in the “DOWN” position.
5. Adjust the fl ow of clean solution to the fl ow desired.
6. Move the machine across the fl oor in the forward direction.
7. Make a 180 degree turn.
NOTE: When you make more passes across the fl oor, let the brushes clean
approximately 2 inches of the area already cleaned by the brushes.
NOTE: During most cleaning procedures, apply and remove the solution in
one operation.