Filter
Top Products
6
Reminder: Make sure the HEPA filter is properly installed before use.
Where to locate:
1) Keep the unit in a place at least 2 yards away from the TV set, radio, etc.
to avoid interference.
2) Do not blow air directly into the air purifier.
3) Keep both sides of the unit more than 6 inches away from the wall.
4) Do not place the unit where the air inlet or outlet grill could come in
contact with a curtain.
5) Place the air purifier in a well-ventilated location of the room.
6) Placing the unit close to the source of the air pollution may further improve
indoor air quality.
HOW TO ASSEMBLE AND USE
Setting the Control Panel for A375UV Ultra
1) Plug the unit into an electric outlet, the unit will be ready to run. Press the On/Off
button to start running, re-press it to stop.
2) When the air purifier is turned on the fan will run at medium speed for 3 seconds
before running at low speed (default speed). Press the speed button each time,
the fan speed will cycle.
3) While the air purifier is on, press the TIMER button to the desired run time
(hours). The air purifier will automatically turn off once the timer has counted
down to zero.
4) Press the ion key to turn on the ionizer while the fan is running, press it again to
turn off the ionizer.
5) Press the UV lamp button to turn on the UV lamp, which is used to help to kill
harmful bacteria in the air. Press it again to turn off the UV lamp.
6) When the HEPA replacement light is lit up the HEPA filters needs to be replaced.
7) When the unit runs in auto mode, the dust and odor sensors can sense the air
quality in the room and automatically adjust the fan speed. The particle sensor