Filter
Top Products
OPERACIÓN
1. Enchufe el ventilador en cualquier toma de corriente estándar de 120V CA de la casa.
2. Utilizando el conmutador rotativo, seleccione la velocidad deseada del ventilador.
3. Para girar el ventilador, afloje los botones en el lado de la rejilla e incline el ventilador para dirigir el flujo del aire.
MANTENIMIENTO
ADVERTENCIA: DESCONECTE SIEMPRE EL CORDÓN ANTES DE INTENTAR REALIZAR CUALQUIER FUNCIÓN DE SERVICIO.
LIMPIEZA: Use un trapo y una solución de jabón suave, tal como detergente líquido para lavar trastes.
ADVERTENCIA: No use gasolina, bencina, acetona, limpiadores abrasivos, etc., puesto que eso dañará el Ventilador, NUNCA
use ALCOHOL o SOLVENTES.
ALMACENAMIENTO: Cuando no lo utilice, mantenga el aparato en un lugar limpio y seco.
EL MOTOR HA SIDO PERMANENTEMENTE LUBRICADO.
OPCIONAL: MONTAJE EN LA PARED
1. Sacar la plantilla para montaje en la pared de esta hoja de
instrucciones.
2. Colocar la plantilla contra la pared a la altura deseada y marcar el
centro de los dos agujeros verticales. Asegurarse que la ubicación
elegida esté centrada en un pie derecho (a menos que se usen
fijaciones o anclajes de pared)
3. Instalar un tornillo (no. 8 x 1-1/4” para madera o uno equivalente
(2x)), NO SUMINISTRADO - comprarlos por separado), en cada
uno de los puntos marcados.
(Figura 1)
4. Apretar los tornillos dejando un espacio de 1/8” a 3/6” entre la
pared y la parte inferior de la cabeza del tornillo.
(Figura 2)
¡IMPORTANTE! ASEGURARSE QUE LOS TORNILLOS ENGRANEN EN EL PIE DERECHO.
5. Montar el ventilador alineando los dos agujeros en el soporte para pared con los dos tornillos en la pared. Una vez que el ventilador esté
colocado, tirar suavemente hacia abajo asegurándose que el ventilador quede firmemente sujeto.
* Para la instalación correcta en paredes de ladrillo, usar anclajes o fijaciones para mampostería, no incluidos, y seguir las instrucciones
siguientes.
Este procedimiento de montaje permite colgar el ventilador horizontal y verticalmente, un total de cuatro posiciones, sin tener que cambiar
de posición los tornillos.
1
2
3
4
5
6
7
8
10
11
12
2
13
11
8
9
LISTA DE REPUESTOS
Ref No. de
No. Parte Descripción Cant.
1 2011056 Botón Interruptor 1
2 2090008 Tornillo #8 x 1/2 Tipo 25 PPH 6
3 02030007AK Ensamblado del Motor con Cubierta
y Cordón Eléctico 1
4 2011051 Rejilla Trasera 1
5 2011053 Hélice 1
6 2091008 Arandela de Bloqueo con Dientes Ext. #12 1
7 2091160 Tuerca Hexagonal 12-24 1
8 2011055 Placa de Trinquete 2
9 2090017 Tornillo #8 x 1/2 Hex Sems 2
10 2011052 Base 1
11 2010415 Pie 4
12 2011054 Soporte de Montaje 1
13 2011050P Rejilla Delantera 1
Figura 1
1/8" - 3/16"
Figura 2
Marcar
El Centro
El Pie
Derecho
MODELO 4TM65A/9530A
AIRKING THREE-YEAR LIMITED WARRANTY. Products are warranted by AirKing to the original user against defects in
workmanship or materials under normal use for three years on the motor and one year on all other parts, after date of purchase.
Any part which is determined by AirKing to be detective in material or workmanship and returned to an authorized service location,
as AirKing designates, shipping costs prepaid, will be, as the exclusive remedy, repaired or replaced at AirKing’s option. For
limited warranty claim procedures, see PROMPT DISPOSITION below. This limited warranty gives purchasers specific legal
rights which vary from state to state.
LIMITATION OF LIABILITY. To the extent allowable under applicable law. AirKing’s liability for consequential and incidental
damages is expressly disclaimed. AirKing’s liability in all events is limited to, and shall not exceed, the purchase price.
WARRANTY DISCLAIMER. AirKing has made a diligent effort to illustrate and describe the products in this literature accurately;
however, such illustrations and descriptions are for the sole purpose of identification, and do not express or imply a warranty the
products are merchantable, or fit a particular purpose, or that the products will necessarily conform to the illustrations or
descriptions. Except as provided below, no warranty or affirmation of fact, expressed or implied, other than as stated in “LIMITED
WARRANTY” above is made or authorized by AirKing.
PRODUCT SUITABILITY. Many states and locations have codes and regulations governing sales, construction, installation,
and/or use of products for certain purposes, which may vary from those in neighboring areas. While AirKing attempts to assure
that its products comply with such codes, it cannot guarantee compliance, and cannot be responsible for how the product is
installed or used. Before purchase and use of a product, please review the product application, and national and local codes and
regulations, and be sure that the product, installation, and use will comply with them.
Certain aspects of disclaimers are not applicable to consumer products; e.g., (a) some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you; (b) also, some states
do not allow limitations on how long an implied warranty lasts, consequently the above limitation may not apply to you; and (c)
by law, during the period of the Limited Warranty, and implied warranties of merchantability or fitness for a particular purpose
applicable to consumer products purchased by consumers, may not be excluded or otherwise disclaimed.
PROMPT DISPOSITION. AirKing will make a good faith effort for prompt correction or other adjustment with respect to any
product which proves to be defective within limited warranty. For any product believed to be defective within limited warranty,
first write or call dealer from whom product was purchased. Dealer will give additional directions.
LIMITED WARRANTY
MODEL 4TM65A/9530A
TEMPLATE
NOT SUPPLIED - Two (2) #8x1-1/4" Wood Screws (Must be purchased separately)
✁
4-1/8" (10.48 cm)
TOP
BOTTOM
Rev. E 7/05
3
2084532
Rev. E 7/05
6
2084532