Filter
Top Products
7
English
Nederlands
FrançaisDeutschEspañol
External output setting
(Default: OFF)
Input the setting code.
Illumination IlluminationBlinks three times Blinking
OFFOFF
During lockout
and forced
entry output
During
Lockout
During forced
entry output
During lockout
and forced
entry output
· If the power is turned off and
the , , and keys are
pressed simultaneously while the
unlock 1 input status is active
(short circuit between terminals
PB1 and C), the settings can be
returned to their default values by
turning the power back on and
pressing the , , and
keys simultaneously for 3
seconds.
· When setting the external output,
do not set the relay 2 output to be
latched.
Input the setting code.
Reset Settings
Illumination Blinking Illumination Blinking
(orange)
Illumination
(green)
Blinking
Input the master code twice.
(Default : )
During
Lockout
During forced
entry output
Bleep, Bleep, Beep
Beep
Bleep, Bleep
Bleep Bleep
Inputting of relay output time
(ex.: 99 seconds)
01 - 99
Latched (
̪
) : 00
· (
̪
) If the latched status has
been set and the door is
unlocked, it will not be locked
again until the user code is
entered (or the request to
exit/entry button is pressed, or
the key is pressed while
timer-linked unlocking is set).
· When the door is unlocked
during relay outputting
(including when latched), the
system cannot be switched to
the setting mode.
When setting relay 1When setting relay 1 When setting relay 2When setting relay 2
Setting the relay output time
(Default: 3 Sec.)
Input the setting code. Input the setting code.
Illumination Blinking
Illumination Blinking
Beep
Bleep
Setting the key illumination time
(Default: 10 Sec.)
Input the setting code.
Inputting of illumination time
(ex.: 20 seconds)
10 - 99
Indicator is lit up at all times: 00
Illumination Blinking
Illumination Blinking
Beep
Bleep
-
When the key is pressed, the green LED lights up, the buzzer beeps twice, and the system exits the setting mode.
(If the key is included in the user code and the master code, the system does not exit the setting mode.)
- You can continue the setting up operation by entering an arbitrary setting code.
Indicator
goes out
Blinking
Bleep,
Bleep