Filter
Top Products
6
To select a Bypass Group when arming the system:
1. Press , then your [access code] (if necessary).
2. Press . The next time the system is armed, the zones in this group will be bypassed.
3. To exit bypassing mode and return to the Ready state, press .
NOTE: A Bypass Group is only recalled if the system is armed/disarmed after programming the by-
pass group.
NOTE: This feature is not to be used in UL Listed installations.
Trouble Conditions
When a trouble condition is detected, the Trouble ( ) indicator will turn on, and the keypad will
beep every 10 seconds. Press the key to silence the beeps. Press to view the trouble con-
dition. The Trouble ( ) indicator will flash. Use the keys to view troubles.
Alarm Memory
When an alarm occurs, the Alarm Memory Message will be displayed. To view which sensor(s) gener-
ated the alarm, press .
For the system keypad use the scroll keys to view the sensors in alarm memory.
Press to exit. To clear the memory, arm and disarm the system.
If an alarm sounded while armed, the system will automatically go to alarm memory when you dis-
arm the system. In this instance, you should approach with caution, as the intruder may still be within
the building/premises.
Door Chime (Entry/Exit Beeps)
To turn the door chime function on or off, press and hold the Chime key for 2 seconds or press
.
Trouble
Condition
Comments Action
Service Required
(Press [1] for more
information)
Indicates Low Battery, System Trouble, System Tamper or
RF Jam detected.
Call for service
Loss of AC Power
If the building and/or neighbourhood has lost electrical
power, the system will continue to operate on battery for
several hours.
Check AC
connection
Call for service
Telephone Line
Fault
The system has detected that the telephone line is dis-
connected.
Call for service
Failure to
Communicate
The system attempted to communicate with the moni-
toring station, but failed. This may be due to Telephone
Line Fault.
Call for service
Sensor (or Zone)
Fault
The system is experiencing difficulties with one or more
sensors on the system. Press [5] to display zone(s).
Call for service
Sensor (or Zone)
Tamper
The system has detected a tamper condition with one or
more sensors on the system. Press [6] to display zone(s).
Call for service
Sensor (or Zone)
Low Battery
If the system has been equipped with wireless sensors,
one or more has reported a low battery condition. Press [7]
to display the zone(s). Press [7] again to display WLS keys.
Call for service
Loss of Time & Date
If complete power was lost (AC and Battery), the time
and date will need to be re-programmed. Press [*]
Re-program Time &
Date (page 4)