Filter
Top Products
Contents
Assembly
Outer Housing x 1
Inner Housing x 1
Rubber Bumper x 2
PCB x 1
Inner Housing End Cap x 1
End Cap x 1
Lens x 1
Screw x 4
Switch x 1
Switch Cover x 1
Magnet x 1
LED Bulb x 1
1. Insert Rubber Bumper in Inner
Housing End Cap and pull to snap in
place.
2. Cut off excess rubber
from Rubber Bumper.
3. Insert second Rubber
Bumper into Inner
Housing and pull using
pliers to snap in place.
4. Cut off excess rubber.
5. Screw PCB onto Inner Housing
making sure wires are connected as
shown.
6. Insert L.E.D. and into
Inner Housing and make
sure L.E.D. is pushed fully
into place.
Make sure the flat side of
the L.E.D. lines up with the
flat side of the L.E.D. socket.
7. Insert Magnet into Inner Housing
and push Inner Housing End Cap into
place.
8. Locate switch in hole in
Flashlight Body.
9. Keeping Outer Housing in
same position as in step 8
carefully insert Inner Housing
and rotate until it fits fully
inside.
10. Place Lens in place with
domed side facing up and
screw shut with End Cap.