Filter
Top Products
14 Aarrow Ecoburn Wood & Multifuel Stoves
INSTALLATION
ADJUSTING THE SELF
LEVELLING FEET
The Aarrow Ecoburn Wood and Multifuel stoves
are equipped with adjustable rear levelling feet,
these are ideal for use where the hearth surface is
not flat or level.
Adjustment is as follows:
• Position the stove on the hearth into its final rest-
ing place, ensuring room for the flue connections
etc.
• On the rear leg of the stove, loosen the pozi screw,
and rotate the inner ‘cam’ shaped levelling foot
until this touches the hearth. (See Fig. 4.).
•Re-tighten the pozi screw. Check the stove is level
with a sprit level.
•Repeat for the other rear leg.
WOOD STOVE VERSION -
WOOD TRAY
The wood burning tray should come fitted in your
stove, if not please follow these instructions -
•Fully open the fire door , and remove the two round
fuel retaining bars,
•Locate the front of the wood tray, this is the end
with no tabs protruding from each side,opposite to
the rear end with the tabs protruding either
side.(See Fig. 5.)
•Holding the front edge of the wood tray, carefully
insert the wood tray into the firebox, taking care not
to damage the paint work and side / rear liner pan-
els.
•Engage the rear lugs into the slots athe the rear of
the side landings. Then lower the front of the tray
until this rests onto the front brace of the stove.
(See Fig. 6.)
Fig. 4. Adjusting the rear feet
Front
Rear Lug
Fig. 5. Wood tray identification
Fig. 6. Wood Tray Installed