3M 700 Series Carbon Monoxide Alarm User Manual


 
System Configurations
Power requirements
A dedicated power line is recommended but not required.
Voltage
100/120 VAC 50 or 60 Hz 220/240 VAC 50 or 60 Hz
Amperes
1.8 A @ 100/120 VAC 1.0 A @ 220/240 VAC
WARNING
To reduce the risks associated with hazardous voltage:
Do not use the product if the case, covers, or power cord are damaged.
Do not attempt to modify, service, or repair—no user serviceable parts inside—contact 3M Service for repair.
Detection zone
The primary zone of detection is in areas where patrons typically carry items. The electronic coverage in this zone is not
100%, however, the rate of detection is effective to deter the loss of protected materials. It is important to watch for suspicious
actions such as holding materials above or outside the lattices when passing through the system.
Indicators
Type Description
Power indicator Green LED on the electronics enclosure indicates power on.
Slave indicator Yellow LED on the electronics enclosure indicates that 2 controllers are connected.
Lattice alarm lights
Audible alarm
Indicates an Alarm.
Alarm outputs
Visual
Visual alarm indicator lights are located on top of each lattice. If the lights are on, an alarm condition has
occurred.
Audio
An audible alarm speaker is mounted on each lattice. Alarm volume can be adjusted by a technician.
10
Copyright © 2008. 3M. All rights reserved.