Filter
Top Products
3
R
ELEASE
I
SSUES
This chapter discusses the following issues for major software
Release 3.0:
■
Corrected Problems
■
System Issues
■
Known Problems
■
Documentation Changes
Corrected Problems
This section discusses problems that have been corrected in software
Release 3.0.
The numbers that appear in parentheses at the end of some descriptions
are for internal 3Com use only.
System
■
The system no longer displays
os socket err
after you reset the
chassis and during the system start-up procedures. (27650 and 29672)
■
The 36-port 10/100BASE-TX Layer 2 modules (Model Numbers
3CB9LF36R and 3CB9LF36T) no longer experience port lockup due to
high port errors. (28668)
Management
■
Uploading a configuration file to a TFTP server no longer removes the
file from the EME file system, as shown in the
show file
display.
(23456)
Ethernet
■
On Layer 2 modules with fiber interfaces, the port mode defaults to
100half, and no longer initially displays
100full
as the state when
you enter an
ethernet portstate
command. (25985)
■
The 36-port 10/100BASE-TX Layer 2 Fast Ethernet RJ-45 module
(Model Number 3CB9LF36R) no longer asserts because of port duplex
mode mismatch and TX underrun errors. (27365, 27362, and 29195)