Filter
Top Products
CHANGING YOUR CODE
ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN
1). Enter “zero” six times.
2). Enter your existing six (6) digit code one time.
3). Enter your NEW six (6) digit code two times.
4). If a mistake is made wait thirty (30) seconds and repeat steps 1 - 3.
5). Test lock operation several times before closing the door.
• Valid Code Entry - Double signal after valid six (6) digit code is entered.
• Invalid Code Entry - Triple signal and old code is still valid.
BATTERY LOW WARNING
• Repeated beeping during an opening indicates that the battery is low and
needs immediate replacement.
• Uses one (1) 9-Volt Alkaline Battery. LA GARD recommends the use of
Duracell™ or Eveready™ Alkaline batteries. LA GARD recommends the
replacement of batteries at least once annually.
If battery is depleted and will not allow lock to open, simply follow instruc-
tions below. Lock contains a non-volatile memory, even with the batteries
removed the lock will retain all pro-
gramming.
CHANGING YOUR BATTERY
Note: Some manufacturers use a small screw to
secure the battery compartment cover to the key-
pad housing. If your model has this screw, it must
be removed first before following the steps listed
below.
1). Remove black plastic battery
compartment cover (located at the
bottom of the keypad) by gently
pulling downward on its handle.
2). Allow the battery and its attached
leads to drop down and out of the
battery compartment. If it does
not drop, gently pull on the battery
until it does.
3). The connector is easily removed
by unsnapping it from the two
terminals on the top of the battery.
Never Pull on the Battery Leads
4). Connect a new 9-Volt Alkaline
battery to the battery clip.
5). Push the battery and the leads
completely up into the
battery compartment.
6). Install the battery cover by placing
one side of the cover in position
and then pressing the other side
into position with your finger.
© copyright 2006 (P/N) 12-220 rev 4 • 7/07 LA GARD - A Member of The Kaba Group
page 2 of 2