Energy Display Owner’s Manual
Page 7 of 13 2448A2 - Rev: 1/21/2014 8:45 AM
Setup Modes
Mode/Setup
To enter Setup Mode, press & hold the Mode/Setup button until the cost setting field
begins blinking. Then tap the Mode/Setup button to cycle to the desired settings.
To exit Setup Mode:
• Tap the Refresh/OK button to accept the current value
• Wait for Energy Display to time out and automatically accept the current value (~1 minute)
• Tap the Mode button to accept the current value and move to the next Setup Mode
Once Energy Display exits a setup mode, it will return the screen to Display Mode.
Cost Setting
NOTE: Green text indicates flashing text on the Energy Display screen.
Range is 0.1 to 999 cents/kWhr ($9.99/kWhr). Once the counter reaches 999 cents, it will reset to 0.1
cents. The default is 10 cents.
Hold/Up
Tap up to increase or down to decrease the cost.
If cost is less than 100 cents, cost will change by 0.1 cents.
If cost is greater than 100 cents, cost will change by 1 cent.
Press & hold to continuously increase or decrease cost.
1-2-3/Down
Refresh/OK
Tap to accept current Cost setting and exit Setup Mode
Mode/Setup
Tap to cycle to the next setting mode (Temperature Format)
