1. Manuals
  2. Household Appliance Support
  3. York Support
  4. Furnace Support
Support User Manuals
Question About York Furnace pblul016n080a
No heat...

Igniture lights but we dont get any flames. if i tap on valve and gas pipe then it will lite and run for a while then the problem comes back

Asked by Mike on 02/19/2009 2  Answers

ManualsOnline posted an answer 15 years, 7 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

steven posted an answer 15 years, 6 months ago

0 I think you probably know the answer to this one. Sounds like your gas valve sticking shut. Either that or the control wire connector going to the valve is corroded/bad and is introducing just enough resistance in the circuit that it does not provide enough juice to open it and the banging on it helps just enough to open it. Only mention that because connections can get oxidized over time and can cause problems that you wouldn't ever think be related.
Was this answer helpful?

steven posted an answer 15 years, 6 months ago

0 I should have said a little more. You may have to replace the valve. If it's a connector then changing the connector would be cheap and relatively easy. I'm sure you know someone that has a set of wire strippers that could do that for you. You can pick up connectors cheap at any Lowe's or Home Depot store.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual