1. Manuals
  2. Household Appliance Support
  3. White Rodgers Support
  4. Thermostat Support
Support User Manuals
Question About White Rodgers Thermostat None
Need an owner manual for a thermostat...

Looking for an owner manual on a thermostat model number 1f82-261. The situation that is happening with my thermostat is; everytime I turns on the heat and set it at 72 degrees or high the flame symbol starts to flashing. What do this indicates and what do I need to perform to prevent this from happening? Please email me the information that I am requesting. Thank you.

Asked by D. Lockett on 10/20/2008 6  Answers

ManualsOnline posted an answer 16 years, 1 month ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Barbara Johnson posted an answer 15 years, 10 months ago

0 I need a diagram of the face plate explaining what each arrow means. Should aux always be on?
Was this answer helpful?

Barbara Johnson posted an answer 15 years, 10 months ago

0 Why does the unit continue to run for 20 or thirty minutes once it has reached the temperature it was set for?
Was this answer helpful?

Chenaz posted an answer 15 years, 9 months ago

0 I have the same problem with the flame symbol flashing and I do not hear the furnace kicks in like before.
Was this answer helpful?

Thomas posted an answer 15 years, 9 months ago

0 The flashing flame indicates auxilary heat is running, Try to set the temperature 2 degrees above room temp and it should be the solid flame. The reason the unit continues to run is because the thermostat is set with a 1/2 degree differential, which means if you set it on 70 it will reach 70 1/2 before it shuts off.
Was this answer helpful?

Chenaz posted an answer 15 years, 9 months ago

0 Thank you so much, I have had it on 68 degrees all winter and it was only a few days ago I noticed it flashing and the room a liitle cooler than normal. I will try thjis methid and see wht gives. Thanks for your input.
Was this answer helpful?

Chenaz posted an answer 15 years, 9 months ago

0 Bottom line was that the motor in the furnace was DONE - when the flame symbol comes on flashing an indication that the motor is going or is done - mine was DONE. I called the technical support in St. Louis and they advised me - I called heating and air and that was the case. Guys good luck - I had American Home Shield so it was the greatest help at this time only having to pay a service fee of $55.00. Now I am up and running nice and warm. - Hope this helps.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual