1. Manuals
  2. Household Appliance Support
  3. Genie Support
  4. Garage Door Opener Support
Support User Manuals
Question About Genie Garage Door Opener PMX500IC/B
How do I reset the keypad code on a Genie PMX 500...

How do I reset the keypad code on a Genie PMX 500 IC/B garage door opener?

Asked by Roger on 01/12/2014 3  Answers

ManualsOnline posted an answer 10 years, 11 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Rewarder User posted an answer 10 years, 9 months ago

5 Step 1 - Activate programming mode. Press in order 3, 5, 7, PROG button - Red LED blinks - once per second Enter you PIN ( 3 to 8 characters) Press PROG button - Red LED blinks - twice per second and turns off. Step 2 - Programming One Door Openers Find the Learn Code Button and Learn Code Indictor LED on your door opener. (This can be found where you see the antenna wire hanging from the motor head (you may have to take the lens cover off). If antenna wire is not hanging from motor head then you have an external receiver which is a black box approx. 6" x 2" mounted somewhere in the garage with a antenna wire hanging from it (pop off cover to find Learn Code Button). Press the Learn Code Button - Learn Code Indictor LED (on opener) will blink. Enter your PIN and Press the up/down arrow button on keypad - Learn Code Indicator LED stays on. Press the up/down arrow button again - Learn Code Indicator LED turns off - Wait until Keypad Backlight turns off approximately 30 seconds. Step 3 - Operating One Door Opener To operate the Garage Door - Enter your PIN - Press the up/down button. NOTE: If the Door does not move, check the red LED on the keypad. If the LED is blinking rapidly, the PIN was entered incorrectly. After the LED stops blinking, re-enter your PIN and try again. Any Keypad button will control the door for 30 seconds after the door starts moving. Rapid blinking of the red LED indicates an error. After a few seconds the LED will turn off. Start over. http://www.genie-garage-door-openers.com/newgwkiccoding.htm The key pad has digits 0-9, send and prog, there is no up/down button. Also, when I pushed 3, 5, 7 the LED lights blinked as I pushed the buttons but after I pushed prog it did not blink once per second
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual