1. Manuals
  2. Household Appliance Support
  3. Dyson Support
  4. Vacuum Cleaner Support
Support User Manuals
Question About Dyson Vacuum Cleaner DC07
Dyson Vacuum Cleaner...

How do I connect the attachments to the flexible hose and how do I connect the flexible hose?

Asked by George on 09/26/2010 8  Answers

ManualsOnline posted an answer 14 years, 1 month ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Msgee posted an answer 14 years, 1 month ago

0 The hose is already attached, just pull it up form the cleaner and attach the attachments,
Was this answer helpful?

Maria posted an answer 14 years, 1 month ago

0 I have had my cleaner for aprox. 10 years and have loved it. My problem now is that it doesn't pick as it should. I have cleaned the filter, empyied the bag but am wondering if I am doing something else woron. I don't know if the "brush bar/off-on" may have something to do with my prob. thanks Maria
Was this answer helpful?

Msgee posted an answer 13 years, 1 month ago

0
Was this answer helpful?

Ian posted an answer 12 years, 10 months ago

0 There is a button just above the power switch at the front of the handle, pressit to release the handle and pull the handle upwards. The entire metal tube comes out, it will lock at the bottom, press the small button to release it and pull the metal tube out completetly. Then attach the plastic collar on the hose to the other end of the handle after moving the guard forward. The tools fit on the metal end. I hope this helps.
Was this answer helpful?

Ian posted an answer 12 years, 10 months ago

0 If the cleaner stops unexpectedly during use it may be because the motor is overheated. Dysons have a thermostat which cuts the power if there is not a free flow of air cooling the motor. This is usually caused by a blockage, which can be easily cleared on the DC07 by removing the access points on the bends. One is on the right side towards the back and the other is underneath the flexible hose. Once the blockage is cleared the cleaner will work again after about thirty minutes.
Was this answer helpful?

Ian posted an answer 12 years, 10 months ago

0 I rescued my DC07 from a skip. There was a carrier bag hanging out of the bottom of it so I knew it was only blocked. It took me about an hour to clear all the dried mud, twigs, wire, pet hairs and the carrier bag out of it and it has worked perfectly ever since. Some people seem to expect too much of these machines.
Was this answer helpful?

Ian posted an answer 12 years, 10 months ago

0 If the suction on your DC07 doesn't seem as powerful as it used to be try cleaning the sponge filter and it's holder. The filter is located at the bottom left of the body, it just pulls out with a push button clip. wash both the filter sponge and it's holder in clear running water until the water runs clean, then leave to dry completely before refitting. Also when you empty the dirt holder, remove the outer shroud by releasing the clip at the front, then holding the handle firmly, slap the cyclone assembly firmly with the palm of your hand, don't use anything harder. You will be surprised at the amount of compacted dust that falls out. Also clear any debris from the grill around the top. I was surprised how much more powerful my DC07 was after doing this.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual