1. Manuals
  2. Household Appliance Support
  3. Bryant Support
  4. Furnace Support
Support User Manuals
Question About Bryant Furnace 395CAV 048075
burner will not stay lit....

Replace the lighting element. check all connection, ohms all switches & wiring, fuses. what do I do now

Asked by james on 11/30/2009 7  Answers

ManualsOnline posted an answer 14 years, 11 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Stephen posted an answer 14 years, 10 months ago

0 I am assuming your ignitor is not staying lit? If so..where it connects to the circuit board usually located in the fan housing (compartment below)...unplug it off the board (usually labeled "IGN" or "HSI"). Now take a voltmeter and connect one prong...usually the red...to this connection and touch the other one to a ground (usually the metal box where the high voltage enters the furnace).
Was this answer helpful?

Stephen posted an answer 14 years, 10 months ago

0 Watch this after resetting the on and off switch...if it stays at 115v to 120v...it's your ignitor...if it drops to zero after a few seconds..it's your circuit board..replace it
Was this answer helpful?

Stephen posted an answer 14 years, 10 months ago

0 Watch this after resetting the on and off switch...if it stays at 115v to 120v...it's your ignitor...if it drops to zero after a few seconds..it's your circuit board..replace it
Was this answer helpful?

Stephen posted an answer 14 years, 10 months ago

0 Watch this after resetting the on and off switch...if it stays at 115v to 120v...it's your ignitor...if it drops to zero after a few seconds..it's your circuit board..replace it
Was this answer helpful?

Stephen posted an answer 14 years, 10 months ago

0 Watch this after resetting the on and off switch...if it stays at 115v to 120v...it's your ignitor...if it drops to zero after a few seconds..it's your circuit board..replace it
Was this answer helpful?

Stephen posted an answer 14 years, 10 months ago

0 Watch this after resetting the on and off switch...if it stays at 115v to 120v...it's your ignitor...if it drops to zero after a few seconds..it's your circuit board..replace it
Was this answer helpful?

Stephen posted an answer 14 years, 10 months ago

0 Sorry about repeats..this site not good at letting you know it's submitted! My mistake. Touch the red prong to the board labeled IGN or HSI...not the wire from the ignitor..and don't touch any metal with your body
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual