Whirlpool ACQ058MM0 Air Conditioner User Manual


 
9
The louvers in the top of the front
panel allow you to control the
direction of the cooled air. Roll the
wheel up or down to direct the air
left or right. Use the tabs to move
the whole cartridge to direct air up,
down or straight ahead.
Along with using POWER SAVER (some models), there are many things you can do to help save energy.
When your air conditioner is operating normally, you may hear sounds such as:
Changing air direction
Saving energy
Normal sounds
Droplets of water hitting the condenser, causing a
pinging or clicking sound. The water droplets
help cool the condenser.
Air movement from the fan.
Clicks from the thermostat cycle.
Vibrations or noise due to poor wall or window
construction.
A high-pitched hum or pulsating noise caused by the
modern high-efficiency compressor cycling on and off.
Improve your home's insulation. Seal doors and
windows. Close fireplace flue.
Close blinds or drapes on the sunny side of your
house. Add awnings.
Make sure drapes or furniture do not block airflow from
your air conditioner.
Turn lights and appliances off when they are not
needed.
Ventilate your attic. High temperatures in the attic add
to the air conditioner's cooling load.
Try not to use heat-producing appliances during the
hottest part of the day.
Keep heat registers and cool-air returns closed.
Use exhaust vent fans while cooking, doing laundry, or
bathing.
wheel
tab
To operate air conditioner with remote control
NOTE: Two AA batteries (not
included) power the remote
control. Replace batteries after
six months of use, or when the
remote control starts to lose
power. Be sure to install
batteries with correct polarity.
To turn the air conditioner on or off: Press
the POWER ON/OFF button.
To raise the temperature: Press
the
button. Each time you press or hold
the
button, the temperature will go up 1°
until it reaches 86°F (30°C).
To lower the temperature: Press
the
button. Each time you press or hold
the
button, the temperature will drop 1°
until it reaches 64°F (18°C).
To select the mode: Press the AutoCool,
Cool, Fan Only, or Power Saver button.
When air conditioner is operating in
AutoCool mode, fan speed is adjusted
automatically. When air conditioner is
operating in Fan Only mode, fan speed is
automatically set at Turbo. When air
conditioner is operating in Cool or Power
Saver mode, you can adjust the fan speed.
To select the fan speed (in Cool or
Power Saver mode only): Press the
Turbo, High or Low button.
To set Timer for a 1 to 24 hour delay
until air conditioner turns on (air
conditioner must be in OFF mode):
1. Press the Timer button.
2. Press the
button to change delay time
(1 to 24 hours).
3. Press the Timer button again or wait 10 seconds.
To set Timer for a 1 to 24 hour delay until air
conditioner turns off (air conditioner must be
in ON mode):
1. Press the Timer button.
2. Press the
button to change delay time
(1 to 24 hours).
3. Press the Timer button again or wait 10 seconds.
NOTE: In the event of a power failure, your air
conditioner will operate at the previous settings when
the power is restored.