Filter
Top Products
Caring For Your Air Conditioner
Continued
Electrical Shock, Product Damage and
Personal Injury Hazard
l
Unplug power cord from receptacle before
performing any maintenance. De sure no
liquid gets into the motor, electrical control
box or compressor electrical terminals.
l
Do not lift, push or pull any white beaded
foam (expanded polystyrene) parts.
l
Because your air conditioner weighs from
110 to 200 pounds, it is recommended that
you have someone help you when you
remove and re-install your unit and that
you both use proper lifting techniques.
l
Handle the air conditioner with care. Watch
out for the sharp metal fins on the front
and rear condenser coils.
l
Do not use the collected water for drinking
purposes. lt is not sanftary.
Failure to follow the above precautions
could result in electrical shock, product
damage or personal injury.
1. Unplug power cord.
2 Remove front panel. (See page 5 for
instructions.)
3. Slide unit out of cabinet by using the handle in
the center of the base flange.
4. Wrap the motor, connector plug, electrical
control box and compressor terminal box in
plastic film and make sure no water or other
liquid gets inside any of these parts. It could
damage the insulation and cause serious
mechanical problems.
5. Carefully clean and hose out the base, con-
denser coils and condensate pans. Clean at
least once a year-or more often if the con-
denser coil and pan collects dirt, sand, leaves,
insects or algae. Also, clean if you detect an
odor coming from the air condiiioner.
6. Remove plastic film from motor and electrical
parts.
7. Replace unit in cabinet.
6. Replace front panel.
9. Plug in power cord.
NOTE: ft is a good idea to wait 24 hours before
starting the unit again. This allows for all areas to
dry out. The water from rainfall or from normal
operation does not harm these components.