Filter
Top Products
30
HOW TO ACTIVATE THE OPENER
WARNING: Never let children operate or play with
door controls. Keep remote control away from chil-
dren.
Use any of the following devices:
1. The Remote Control Transmitter; momentary push of the button and the door will start to move.
2. The Wall Station Up/Down button; push momentarily the button until the door starts to move. Constant push of the
button, until door is closed is required if light flashes (indicating a Safety Sensor obstruction).
3. The Wireless Keyless Entry System; (see below)
4. The Outside Key Switch (see manufacturer’s instructions for use of this device).
HOW THE DOOR MOVES WHEN THE OPENER IS ACTIVATED
WARNING: Always keep moving door in sight and away from people and objects, until it is com-
pletely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.
1. If open, the door will close. If closed, the door will open.
2. If closing, the door will stop. Next activation will open.
3. If opening, the door will stop. Next activation will close.
4. If an obstruction is contacted or the beam is interrupted while closing, the door will reverse and the light will flash.
5. If an obstruction is encountered while opening, the door will stop and the light will flash. The next activation will
close the door.
6. The Infrared Safety Sensor uses an invisible beam which, when broken by an obstruction, causes a closing door
to reverse, prevents an open door from closing and causes the light to flash.
7. If door stops travel for 1 second at midpoint during close and then continues to close, it indicates that the batteries
in the Wireless Infrared Safety Sensors are weak and need replacement.
HOW THE LIGHT WORKS AND WHAT IT MEANS WHEN IT FLASHES
1. Overhead light automatically turns on when opener is activated and remains on for 4 minutes for convenience and
safety.
2. The light will flash after coming upon an obstruction in the up or down direction to warn you of a problem. It will
continue flashing for 4 minutes, and then shut off.
If the light begins to flash and the door moves a short distance and then reverses from a wall station button,
transmitter or keyless entry, the external safety sensor device is activated or defective. To temporarily override
and close door, activate wall station up/down button, keeping button depressed; opener will begin in down direc-
tion. The button must remain depressed until cycle is completed. If the button is release before cycle is com-
pleted, the door will reverse and come to full up position. Problems in the safety system should be inspected by
a professional garage door installer.
HOW TO OPERATE THE WIRELESS KEYLESS ENTRY (if Included)
1. Enter the 5-digit PIN number assigned to the door. Door will move. Unit remains active for 25 seconds. Pressing
any key will stop the door if opening and stop or reverse the door if closing. NOTE: If an error is made entering
codes, simply press and hold both the “7/8” and “9/0” buttons for two seconds. The Keyless Entry will
reset.
WARNING: Never let children operate or play with door controls. Keep remote control away from
children.
O
p
eration of Your O
p
ene
r