Wayne RPP50 Plumbing Product User Manual


 
Operating Instructions
Instructions d’Utilisation
Manual de Instrucciones
Notes
Notas
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the
product described. Protect yourself and others by observing all safety information. Failure to comply with instructions
could result in personal injury and/or property damage! Retain instructions for future reference.
Description
This sewage pump is suitable for
pumping sewage, effluent, wastewater,
groundwater and other nonexplosive,
noncorrosive liquids with up to two
inch solids. The pump includes a wide
angle float switch that turns the pump
on and off as the fluid level rises and
falls.
Unpacking
Inspect this unit before it is used.
Occasionally, products are damaged
during shipment. If the pump or
components are damaged, return the
unit to the place of purchase for
replacement. Failure to do so could
result in serious injury or death.
Operating Instructions Model RPP50
331300-001 8/04
Safety Guidelines
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
Danger indicates
an imminently
hazardous situation which, if not
avoided, will result in death or serious
injury.
Warning indicates
a potentially
hazardous situation which, if not
avoided, could result in death or
serious injury.
Caution indicates a
potentially
hazardous situation which, if not
avoided, MAY result in minor or
moderate injury.
Notice indicates
important
information, that if not followed, may
cause damage to equipment.
NOTICE
!
CAUTION
!
WARNING
!
DANGER
General Safety
Information
1. Know the pump application,
limitations, and potential hazards.
Do not use to pump
flammable or explosive
fluids such as gasoline, fuel
oil, kerosene, etc. Do not
use in flammable and/or explosive
atmospheres. Use pump only with
liquids compatible with pump
component materials. Failure to follow
this warning can result in personal
injury and/or property damage.
2. Make certain that the power source
(electric motor) conforms to the
requirements of the equipment.
Disconnect power before
servicing. If the power dis-
connect is out of sight, lock
in the open position and
tag it to prevent unexpected
application of power. Failure to do so
could result in fatal electrical shock!
!
DANGER
!
WARNING
© 2004 Wayne Water Systems
Specifications
Power supply requirements......120V, 60 hz
Circuit requirements..................15 amps (min)
Motor duty.................................Intermittent
Motor .........................................120V, 1 Phase
Horsepower ...............................1/2
Motor full load..........................6.3 amps
Liquid temperature range ........40°F to 120°F
Max. operating position ...........45
o
from vertical
Dimensions.................................14” x 12”
Intake .........................................2”
Discharge....................................2” NPT female
Cut-in level (factory set)............16”
Cut-out level (factory set).........7.5”
Differential.................................8.5”
Switch.........................................90
o
wide angle
mechanical tether switch
Power cord.................................18 gauge 3 conductor
w/plug
Construction
Motor housing...........................Cast iron
Volute.........................................Cast iron
Impeller......................................Glass reinforced PBT
Seal plate....................................Cast Iron
Shaft seal....................................Mechanical
GALLONS PER HOUR AT TOTAL HEAD IN FEET
Model 0 5 10 15
RPP50 5700 4560 3240 900
Performance
1/2 HP Cast Iron
Sewage Pump
For parts, product & service information
visit www.waynepumps.com