■English 5
■ Outdoor Unit
■
■■
■ Indoor Unit
1. Air filter
2. Air-purifying filter with photo catalytic
deodorizing function:
• These filters are attached to the inside of the
air filters.
3. Air inlet
4. Front panel
5. Panel tab
6. INTELLIGENT EYE sensor:
•
It detects the movements of people and
automatically switches between normal operation
and energy saving operation. (page 18.)
7. Display
8. Air outlet
9. Flaps (horizontal blades):
(page 12.)
10. louvers (vertical blades):
•
The louvers are inside of the air outlet. (page 13.)
11. Operation lamp (green)
12. TIMER lamp (yellow):
(page 20.)
13. HOME LEAVE lamp (red):
• Lights up when you use HOME LEAVE
Operation. (page 16.)
14. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
•
The operation mode refers to the following table.
• This switch is useful when the remote
controller is missing.
15. Room temperature sensor:
• It senses the air temperature around the unit.
16. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start ........ beep-beep
• Settings changed...... beep
• Operation stop.......... beeeeep
■
■■
■ Outdoor Unit
17. Air inlet:
(Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
21. Earth grounding terminal:
• It is inside of this cover.
Appearance of the outdoor unit may differ from some models.
19
20
21
18
17
Mode
Temperature
setting
Airflow rate
AUTO 77°FAUTO
01_EN_3P141693-2C (A4).fm Page 5 Saturday, September 25, 2004 11:39 AM