Filter
Top Products
WARNING MESSAGE CLEAR COMMANDS
Command Warning Message Cleared
"W WSYSRES<CRLF>" SYSTEM RESET
"W WRAMINIT<CRLF>" RAM INITIALIZED
"W WSOURCE<CRLF>" SOURCE WARNING
"W WBHEAT<CRLF>" BENCH HEAT SHUTDOWN
"W WWHLTEMP<CRLF>" WHEEL TEMP WARNING
"W WSMPFLOW<CRLF>" SAMPLE FLOW WARNING
"W WSMPRES<CRLF>" SAMPLE PRESSURE WARNING
"W WSMPTEMP<CRLF>" SAMPLE TEMP WARNING
"W WBOXTEMP<CRLF>" BOX TEMP WARNING
"W WBNCHTEMP<CRLF>" BENCH TEMP WARNING
"W WDYNZERO<CRLF>" CANNOT DYN ZERO
"W WDYNSPAN<CRLF>" CANNOT DYN SPAN
"W WVFINS<CRLF>" V/F NOT INSTALLED
TABLE 7.2
7.3 Status/control
This subset of messages is concerned with reporting the status of the Analyzer and
controlling the Analyzer remotely. Whenever the Analyzer does a calibration it issues a
report to the RS-232 output. The table on the following page summarizes the status
reports.
STATUS REPORTS
Report
"C DDD:HH:MM IIII START ZERO CALIBRATION"
"C DDD:HH:MM IIII FINISH ZERO CALIBRATION"
"C DDD:HH:MM IIII START SPAN CALIBRATION"
"C DDD:HH:MM IIII FINISH SPAN CALIBRATION"
"C DDD:HH:MM IIII START MULTI-POINT CALIBRATION"
"C DDD:HH:MM IIII FINISH MULTI-POINT CALIBRATION"
"C DDD:HH:MM IIII START CALIBRATION HOLD"
"C DDD:HH:MM IIII FINISH CALIBRATION HOLD"
TABLE 7.3
To do a remote adjustment via the RS-232 interface, the host computer should issue a
message with the following format:
"C COMMAND<CRLF>
The commands are summarized in the table below:
P/N 02163G1 Teledyne API Model 300 CO Analyzer Instruction Manual - Page 64