©2008 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved.
P.N. 129857 / BCM5555CN/BCM7305RCBCN08EFQSG1/9100030005498
MIST OUTPUT IS MINIMAL TO NONE
Reason:
This humidier provides a cool, invisible moisture.
It is normal not to see mist.
Solution:
Refer to Mode Button section to adjust humidity.
HUMIDIFIER RUN TIME VARIES BETWEEN USES
Reason:
Run time for this humidier is based on average room condition
and can be aected by temperature, humidity level, room
construction, and air exchange.
Solution:
To extend run time, use the Auto mode and set your desired humidity level.
HUMIDIFIER HUMIDITY DOES NOT MATCH ROOM HUMIDITY
Reason:
The humidier can only sense/obtain the humidify level near the
humidier. Actual room humidity may be slightly dierent.
Solution:
Place humidier in center of room for better circulation.
HUMIDIFIER CONTINUOUSLY DISPLAYS 21%
Reason:
Humidity at the humidier is at or below 21%
Solution:
Continue to operate humidier to raise the room humidity.
HUMIDIFIER CONTINUOUSLY DISPLAYS 90%
Reason:
Humidity at the humidier is at or above 90%
Solution:
Stop operating the humidier if the humidity level is too high.
TROUBLE SHOOTING
If you’re still having trouble –
Do not return product to store!
Please call:
1
800
253
2764
SET TIMER
AUTOMATICALLY TURNS HUMIDIFIER ON/OFF
Press & Hold BOTH ARROW BUTTONS for 2 SECONDS until 00 blinks.
Then using one arrow select desired time
(1 hour increments).
Displays room humidity when
humidier is plugged in and after setting
mode, humidity or timer.
(Go to step 2 SET HUMIDITY)
MODE BUTTON
PROVIDES CONTINUOUS
HUMIDITY OUTPUT
OFF (OF) HIGH HUMIDITY (3)
MED HUMIDITY (2) LOW HUMIDITY (1)
AUTO HIGH HUMIDITY (A3)
AUTO MED HUMIDITY (A2)
AUTO LOW HUMIDITY (A1)
AUTOMATICALLY
MAINTAINS SET HUMIDITY
SET DESIRED
MODE
Humidity cannot be set
in High, Med or Low setting
1 .
MODE/OFF BUTTON
Push twice to select Mode;
Hold to turn O
TIMER LIGHT
SET HUMIDITY
ARROW BUTTONS
AUTOMATICALLY CYCLES ON/OFF
TO MAINTAIN SET HUMIDITY!
In (A3), (A2) & (A1) Mode
Default SET HUMIDITY may be less than
Room Humidity. Humidier will not operate
in AUTO MODE if the SET HUMIDITY is less
than Room Humidity, adjust as required.
up down
in A3 (AUTO HIGH),
A2 (AUTO MED) &
A1 (AUTO LOW) ONLY
2 .
IIIuminates when
Timer is set
P/N:BCM5555CN/BCM7305RCBCN08EFQSG1/129857/9100030005498
size: 8.5 inch (W) X 11 inch (H)
- 4-C printing
- 95gsm matt coated paper
- Double-sided printing (English Front / French Back)
- 2-fold leaet (fold 2 times, English to outside)