State Industries 200 Series Electric Heater User Manual


  Open as PDF
of 2
 
THIS PRINTOUT IS FOR REFERENCE ONLY!
Do not use this printout for color match or critical dimensions.
Printout made at 65% of final size.
THIS FILE HAS NOT BEEN TRAPPED.
This file was created with Adobe Illustrator CS.
DO NOT try to open this file with earlier versions.
Marketing Support Inc. assumes no responsibility for final print quality and
will not be held liable for errors or omissions due to alterations made to this
document by client, film or print vendor.
MSI requires a Chromalin or color key type proof for final approval.
If you have any questions about this file, or require further assistance,
contact MSI at 312-565-0044 .
Front
For Additional Technical Information,
PHONE 800-365-0024
STATE WATER HEATERS
500 Tennessee Waltz Parkway, Ashland City, TN 37015
www.statewaterheaters.com
Page 1 of 2
SRGSS00905 REV1
Power-Vent Design – System allows for installation flexibility with
combined horizontal and vertical venting runs using Schedule 40 PVC,
CPVC or ABS pipe.
Intelli-Vent
™
Gas Control – Equipped with nearly indestructible
silicon nitride hot surface igniter, and advanced electronics for precise
temperature control and easy-to-understand system diagnostics. Gas
connection located on side of control, same as conventional gas control.
Modular Blower
– Equipped with 110/120 volt electrical system
(rating 3 amps or less), 6-foot cord, standard 3-prong male connector.
Diffuser Dip Tube – Helps reduce lime and sediment buildup, maximizes
hot water output. Made of State PEXAN
®
, a cross-link PEX polymer that can
withstand long-term exposure to water temperatures up to 400ºF.
Green Choice
®
Eco-Friendly Gas Burner – Patented design reduces NOx
emissions up to 33% and complies with Southern California and Texas requirements.
Durable Brass Tamper-Resistant Drain Valve.
Glass-Lined Tank
– For long-lasting protection against rust and corrosion.
Aluminum Anode Rod – For additional protection against rust and corrosion.
Factory-Installed Temperature & Pressure (T&P) Relief Valve.
Thick, CFC-Free Foam Insulation.
SELECT
®
POWER-VENT
Residential Gas Water Heaters
6-Year Ta n k Warranty • 6-Year Parts War ranty
Code Compliance – All models meet or exceed federal minimum energy standards
effective January 20, 2004, according to latest editions of the National Appliance
Energy Conservation Act (NAECA). They also comply with the latest editions of the
B.O.C.A. National Codes, C.E.C., U.B.C., S.B.C.C., C.A.B.O. and the H.U.D. standards.
All models design-certified by CSA International according to ANS Z21.10.1 standards
governing storage-type water heaters.
200 Series Model