Filter
Top Products
For Dyna, Softail and Sportster models:
When servicing the fuel system, do not smoke or allow
open flame or sparks in the vicinity. Gasoline is extremely
flammable and highly explosive, which could result in
death or serious injury. (00330a)
3. The fuel tank must be removed or slightly raised to access
wiring underneath. See the correct section (Carbureted
or EFI Engine) of the service manual for fuel tank bolt
removal instructions.
If the fuel tank must be removed, follow the instructions
in the service manual to remove the instrument console
(if equipped) from the fuel tank before removing the tank.
TRANSMITTER INSTALLATION
Kits 91558-01A and 91561-01 only
NOTE
Transmitter effective range may vary between motorcycle
models. For best garage door opener range, position the
transmitter on the motorcycle as far as possible from large
metal surfaces.
For best garage door opener performance, keep the trans-
mitter and wires as far from vehicle heat sources as possible
Do not cover the view of the circuitry on the transmitter when
fastening the foam tape retainer pad to the transmitter or
mounting the transmitter to the vehicle. A red LED on the cir-
cuitry side must remain visible for programming the receiver-
transmitter. For best adhesion, use isopropyl alcohol to clean
the surfaces to which the tape pad will mount.
1. See Figure 27. Remove the liner from the adhesive
backing on one side of the tape pad (3). Carefully position
the pad to the plastic casing of the transmitter (1), and
press firmly into place.
2. Find specific model instructions in the sections that follow.
Dyna Models
1. Remove the fuel tank mounting bolts. See the correct
section (Carbureted or EFI Engine) of the service manual.
2. See Figure 2. Use cable straps to fasten the transmitter
to the Dyna wire harness (3), located under the seat and
near the battery compartment. Route the transmitter wires
forward along the right side of the frame.
Proceed to the Harness Connection section.
1
3
2
is06667
1. Orange/white wire
2. Ground connection
3. Strap transmitter to wire harness
Figure 2.Transmitter Mounting (Dyna)
1999 and Earlier Softails
1. Remove the fuel tank mounting bolts. See the correct
section (Carbureted or EFI Engine) of the service manual.
2. See Figure 3. Remove the ground screw (1), located on
the top of the frame, under the seat near the fuel tank.
3. See Figure 27. Use cable straps (8) from the kit to fasten
only the transmitter case and the short section of
conduit to the motorcycle wires leading forward toward
the headlamp.
Proceed to the Harness Connection section.
3
1
2
is06668
1. Ground connection
2. Garage opener transmitter
3. Orange/white wire
Figure 3.Transmitter Mounting (1999 and Earlier Softails)
-J02028 3 of 16