Filter
Top Products
To make cleaning easier, the tanks should
be completely.dried _.
MANUALDRY O_
(a) Loop switch actuator ring around plas-
tic hook located directly above the
switch actuator. (See Figure 7.)
(b) Set Humidity Control to CONSTANT
ON, and Air Flow Control to HIGH.
Run until tank is dry.
e
NOTE: With the switch actuator ring m
place unit will continue to run until the
ring is released. Depending upon
humidity levels, once the tank is empty
the average dry out time is approxi-
mately 2 hours.
__ HINGEDACCESS
J LID
j HO01(
Figure7
SWITCHACTUATOR
J RING
SWITCHACTUATOR
Step 2
When unit is dry, rotate Humidity Control
to OFF and release switch actuator ring.
(See Figure 7.)
Step 3
Unplug humidifier, and proceed to clean.
WARNING
If humidifier is not unplugged, fan
could start after motor support is
removed. "
i J n
Step 4
TO REMOVE PARTS
Raise the hinged access lid. Insert a thin
bladed took(flatbladed screwdriver,butter
knife, etc.)*throughthe slot in the housing
and push up on the detent (Figure 8) and
slide the stationary lid to the side until it
stops (approximately1"); liftthe lid off the
housing.
ACCESSLW
PUSHUPONDETENTlaid
SUOESTATIONARYUO
TOTHESlOE_ IT
REMOVEU0
STATIONARY
LID
SCREWDRIVER
OROTHERTHINBLADEDTOOL
Figure8
ELECTRICALCORD
Step 5
Disengage the electrical cord from the slot
in the housing and carefully rift out the
motor support section (Figure 9). Wipe off
any mineral deposits with a clean damp
cloth.
SECTION
Figure9
Step 6
Before removing filter we recommend
moving humidifier to an area where floor
coverings are not susceptible to water
damage, i.e. kitchen or bath area.
Slide out the filter holder and float.
Remove the filter from inside of the holder
by gently pushing out from either side.
(See Figure 10.)
7