Sears 758.144240 Humidifier User Manual


 
Operating Humidifier Controls
Humidity Control:
This control adjusts the amount of humidity depending on
user's needs. The humidifier will turn on and off as
required to maintain level of humidity you select. (See
Fig. 10) Medium setting is recommended but there are
times when a low or high amount of humidity may be pre-
ferred. For constant operation of humidifier. Constant On
allows for the maximum amount of humidity to be evapo-
rated into the air continuously.
IMPORTANT: Water damage may result if condensation
starts to form on windows or walls. Humidity control set-
ting should be lowered until condensation no longer
forms.
Air Flow Control:
The higher the air flow speed, the faster humidified air is
released into_the air. Low speed is the quietest and is
provided for conditions that may not require as high an
evaporation rate. (See Fig. 10)
Fill Light
When unit has a small amount of water left in it, a red fill
light will come on and unit will shut off. (See Fig. 10)
HU_lorr y CONTROL
KenmoPe []
QUIETCOMFORT
AIR FLOW CONTROL
©
MODEl_ 758.144120
Figure 10
HLIM[OfTY CONTROL
f, r_ ji ,,p.
Kenmore rJ_
QUIE] COMFORT
AIR FLOW CONTROL
vc_
m
r,, l
MODEL 758.144240
Using Your Humidifier
1. Be sure unit is plugged in, full of water and your splash
guard is stored behind motor support section.
2. Set Air Flow Control knob to Low or number 1 position.
(See Fig. 10)
3. Set Humidity Control to Medium position. (,See Fig.
11)
NOTE: Humidifier should operate with humidity control
on the recommended Medium setting. If is does not, the
humidity is at a relatively high level. To test the unit under
this condition, turn Humidity Control all the way to Con-
stant On and unit should begin to operate. After unit has
been tested, set Humidity Control to Medium or desired
level.
Allow 24 hours for humidifier to adjust.
If humidity level in home is sufficient, the humidifier will
only operate with Humidity Control set on Constant On.
IMPORTANT: Water damage may result if condensation
starts to form on windows or walls. Humidity Control set-
ting should be lowered until condensation no longer
forms.
4. If humidifier stops running, the humidity level is at the
normal requirements for that setting or it.is adjusting to
the home conditions. Figure 11 shows approximate rel-
ative humidity percentages which correspond to the
various settings of the Humidity Control.
When Outdoor
Temperature is:
_IO°F
O"F
IO°F
20°F & above
Recommended Indoor
Relative Humidity is
20%
25%
30%
50%
30% TO 50%
F Relative
'_- ME_GH
_ LOW CONSTANTO_
Figure 11