Filter
Top Products
SECTION 2. PREPARE THE MACHINE FOR SEWING
Wind the Bobbin (Continued)
J
Draw thread from spool through
bobbin winding tension disc as shown.
Pull end of thread through hole in
bobbin asshown.
Place bobbin onto bobbin winding
spindle with end of thread coming
from the top of the bobbin. Push
bobbin winding spindle to the right
until it clicks. Holding onto end of
thread, start machine, When bobbin is
slightly filled, snip off end of thread.
Wind thread until winder stops.
Push bobbin winding spindle to the
left and clip thread. Remove bobbin.
Turn clutch knob away from you
while holding hand wheel for normal
sewing operation.
Insert the Bobbin into the Bol bin Case
Place bobbin in bobbin case Pull thread through slot of case Pull thread under tension
making sure thread feeds clock- as shown, spring and through the opening
wise and is coming from as shown above. Pull 3 to4
bobbin as shown, inches of thread from bobbin.
Holding latch open, position Case should lock into place
case into shuttle and release when latch isreleased.
latch.
10